II. FEATURES AND FUNCTIONSLC37/LC37F
5.1 AV NETWORK SETUP WIZARD
5.Follow the steps below to setup your AV network (See page 42 for AV Network Codes).
There are six steps in the setup procedure (DVD setup example below).
HITACHI AV NET SET UP
THUMBDVD
DVDPOWERMENUMORESTICK
Device Code- - - -
Cable Box(Enter code ?9999? to uninstall)
Video InputNo Connection
Photo MC
Audio InputNo Connection
Transmission Test POWERPLAYCH UP
BACK OKEXIT
Move0-9Input
MoveINFODevice Setting
09
HITACHI AV NET SET UPEnter the device (equipment) code listed on page 42.
DVD
Device Code0 6 7 2
(Enter code ?9999? to uninstall)
Video InputNo Connection
Audio InputNo Connection
Transmission Test POWERPLAYCH UP
BACK OKEXIT
Move0-9Input
THUMB
STICK
Proper Code Entered
from page 42.
HITACHI AV NET SET UP
DVDUse THUMBSTICK to select the input that the device (equipment)
Device Code0 6 7 2is hooked-up to.
(Enter code ?9999? to uninstall)
Video InputInput 1
Audio InputNo Connection
Transmission Test POWERPLAYCH UP
BACK OKEXIT
MoveSet Input SEL Select
THUMB
STICK
HITACHI AV NET SET UPTransmission test for the device to confirm that the proper code was
DVDset, by selecting (POWER, PLAY, etc.) soft keys shown. If the device
Device Code0 6 7 2
(Enter code ?9999? to uninstall)responds to the transmission test soft key, then it is properly set up.
Video InputInput 1
Select OK to continue.
Audio InputUsing TV
Transmission Test POWERPLAYCH UP
BACK OKEXIT
MoveSet Input SEL Select
THUMB
STICK
(x2)
HITACHI AV NET SET UPDVDPOWERMENUMORE
DVD
VCR
Device Code0 6 7 2
(Enter code ?9999? to uninstall)Cable Box
Video InputInput 1
Audio InputUsing TVPhoto MC
Transmission Test POWERPLAYCH UP
BACK OKEXIT
MoveSet Input SEL SelectMoveINFODevice Setting
THUMBTHUMBSTICK
STICK
SELECTSELECT
HITACHI AV NET SET UPHITACHI AV NET SETTING LIST
CongratulationsDeviceCodeVideoAudio
Your DVD is nowDVD0672INPUT 1Using TV
connected to your AV network.VCR----Not SetupNot Setup
CBL----Not SetupNot Setup
STB----Not SetupNot Setup
PVR----Not SetupNot Setup
AVR----Not SetupNot Setup
Custom----Not SetupNot Setup
EXIT
SELSelect
6.Enter ?9999? to uninstall the equipment from your AV Network.
7.See Remote Control A/V NET button usage on page 43.
NOTES:1. If your equipment cannot be operated after performing the above procedures, your equipment code has not been pre-
coded into the AV Net.
2. In the unlikely event that your equipment receiver cannot be operated after performing the above procedures, please
consult your equipment receiver operating guide. Please also try the AV Net Learning Wizard on page 47.
41
BACK TO ADJUSTMENTS |