CP-S335(C9SM)/CP-X340, PJ552 (C9X)/CP-X345, PJ562 (C9XM)
3. Names of each part
Part names
I
Projector
Remote sensor
Zoom knob Speaker
Focus ring
Vent
Elevator button
Lens cover
(Slide door)Elevator foot
Lens
Lamp cover
Filter cover
(Lamp unit is inside.)
(Air lter and intake vent
are inside.)
Power switch
Control buttons
(See following page.) AC inlet
Elevator button
Ports
Elevator foot
(See below.)
Vent
AUDIO OUT port Restart switch (*)
AUDIO IN1 port RGB IN1 port
S-VIDEO port RGB IN2 port
AUDIO IN1
Y
COMPONENT AUDIO OUTRGB IN1RGB IN2RGB OUTRGB OUT port
CB/PB
VIDEO ports AUDIO IN2
VIDEOCR/PRCONTROL port
YS-VIDEOUSB
COMPONENT VIDEO
CB/PBCONTROLKensington lock slot
CR/PR
VIDEO port
AUDIO IN2 port
USB port
NOTE (*) About Restart switch: This Projector is controlled by an internal
microprocessor. Under certain exceptional circumstances, the projector may not
operate correctly and the microprocessor will need to be reset. In such a case,
please push the Restart switch by using a cocktail stick or similar and before
turning on again, make the projector cool down at least 10 minutes without
operating. Only push the Restart switch in these exceptional instances.
3 |