BIOS and Setup Program
3.2.5.9 Hard Disk Pre-Delay
Sets the hard disk drive pre-delay. When enabled, this option causes the BIOS to wait the
specified time before it accesses the first hard drive. If your system contains a hard drive and you
don?t see the drive type displayed during boot-up, the hard drive may need more time before it is
able to communicate with the controller. Setting a pre-delay provides additional time for the hard
drive to initialize. The options are:
? Disabled (default)
? 3 seconds
? 6 seconds
? 9 seconds
? 12 seconds
? 15 seconds
? 21 seconds
? 30 seconds
3.2.5.10 Typematic Rate Programming
Sets the typematic rates. The options are:
? Default (default)
? Override (lets you enter Typematic Rate Delay and Typematic Rate options)
3.2.5.11 Typematic Rate Delay
Sets the delay time before the key-repeat function starts when you hold down a key on the
keyboard. If Typematic Rate Programming is set to Default, this option will not be visible. The
options are:
? 250 milliseconds (default)
? 500 milliseconds
? 750 milliseconds
? 1000 milliseconds
3.2.5.12 Typematic Rate
Sets the speed at which characters repeat when you hold down a key on the keyboard. The higher
the number, the faster the characters repeat. If Typematic Rate Programming is set to Default, this
option will not be visible. The options are:
? 6 char/sec (default)
? 8 char/sec
? 10 char/sec
? 12 char/sec
? 15 char/sec
? 20 char/sec
? 24 char/sec
? 30 char/sec
67 |
ACEC
