AV-21LMT3 / AV-21LTR3
AV-21LT3 / AV-21LMG3
AV-2105EE
STATIC CONVERGENCE ADJUSTMENT
1. Input a crosshatch signal.
2. Using 4-pole convergence magnets, overlap the red and blue
lines in the center of the screen (Fig.1) and turn them to
magenta (red/blue).(FRONT VIEW)
3. Using 6-pole convergence magnets, overlap the magenta
(red/blue) and green lines in the center of the screen and turn
them to white.
4. Repeat 2 and 3 above, and make best convergence.
After adjustment, fix the wedge at the original position.
Fasten the retainer screw of the deflection yoke.
Fix the 6 magnets with glue.
Fig.1
DYNAMIC (periphery) CONVERGENCE
ADJUSTMENT
* After adjusting purity & static convergence.
1. Move the deflection yoke up and down and overlap the lines in(FRONT VIEW)
YH
the periphery. (Fig.2)
REDGREENBLUE
2. Move the deflection yoke left to right and overlap the lines in the
periphery. (Fig.3)
BLUERED
GREENGREEN
3. Repeat the steps 1 and 2 and obtain an optimum convergence.
REDBLUE
After adjustment, fix the wedge at the original position.
BLUEGREENRED
Fasten the retainer screw of the deflection yoke.
Fix the 6 magnets with glue.YH
Fig.2
(FRONT VIEW)
GREENGREEN
REDBLUEBLUERED
RED
GREEN
BLUE
YvYv
BLUE
GREEN
RED
Fig.3
30No. 52030 |