AV-36P903
AV-32P903
BASIC OPERATION OF SERVICE MENU
1. TOOL OF SERVICE MENU OPERATION
Operate the SERVICE MENU with the REMOTE CONTROL UNIT.
2. SERVICE MENU ITEMS
In general, basic setting (adjustments) items or verifications are performed in the SERVICE MENU.
1. PICTURE / SOUNDeeeeeeeee This sets the setting values of the VIDEO/CHROMA /AUDIO and DEFLECTION circuits.
2. YC SEPeeeeeeeeeeeeeeeeeee This is used when the YC mode is adjusted. [Do not adjust]
3. LOW LIGHT eeeeeeeeeeeeeee This sets the setting values of the WHITE BALANCE circuit.
4. HIGH LIGHTeeeeeeeeeeeeeee This sets the setting values of the WHITE BALANCE circuit.
5. RF AFC CHK eeeeeeeeeeeeee This is used when the IF VCO is adjusted. [Do not adjust]
6. PIPeeeeeeeeeeeeeeeeeeeeeee This is used when the OUTPUT of PIP data is adjusted. [Do not adjust]
22
7. IC BUSeeeeeeeeeeeeeeeeeee This is used when ON/OFF if the IC BUS control is stop. [Do not adjust]
8. PP eeeeeeeeeeeeeeeeeeeeeee This sets the setting value of the output of P&P data. [Do not adjust]
9. IP eeeeeeeeeeeeeeeeeeeeeeee This sets the setting value of the IP circuit. [Do not adjust]
0. SELF-CHKeeeeeeeeeeeeeeeee This sets the self checking of the TV circuit.
3. Basic Operations of the SERVICE MENU
(1) How to enter the SERVICE MENU.
Press SLEEP TIMER key and, while the indication of ?SLEEP
TIMER 0 MIN.? is being displayed, press DISPLAY key and
SERVICE MENU
VIDEO STATUS key on the remote control unit simultaneously
to enter the SERVICE MENU screen as shown in the Fig.1.1.PICTURE/SOUND7.I2C BUS
2.YC SEP8.PP
3.LOW LIGHT9.IP
4.HIGH LIGHT0.SELF-CHK
(2) SERVICE MENU screen selection5.RF AFC
Press the ten key to select any of the following items.6.PIP
1.PICTURE/SOUND7.I2C BUS
2.YC SEP8.PPFig. 1
3.LOW LIGHT9.IP
4.HIGH LIGHT0.SELF-CHK
5.RF AFC
6.PIPKEY FUNCTION of SERVICE MENU
(3) Enter any setting mode
" 1. PICTURE / SOUND mode
1) Select 1. PICTURE / SOUND items with the number key
and press the function (2 /1 ) key to select the
DISPLAY key
1. PICTURE/SOUND mode. Then the screen will be
displayed as shown in figure in the sub sequent page.
SLEEP TIMERNUMBERS key
2) Then the settings or verifications can be performed.
key
VIDEO STATUS
key
" 2.YC SEP, 3.LOW LIGHT, 4.HIGH LIGHT, 5.RF AFC,
6.PIP, 7.I2C BUS, 8.PP, 9.IP and 0.SELF-CHK mode
1) If you select any of 2.YC SEP 3.LOW LIGHT 4.HIGH
2
LIGHT 5.RF AFC 6.PIP, 7.IC BUS, 8.PP, 9.IP and
MEMORY key
0.SELF-CHK mode items, and the numbers key is pressed(MUTING)
from SERVICE MENU, the each screen will be displayed
as shown in the figure in the sub sequent page.
EXIT key
2) Then the settings or verifications can be performed.MENU key
(PIP OFF)
FUNCTION key
(2/1) & ( / )
Select the setting value
Select the setting Item
No. 5200821 |
ACEC
