AV-48WP30
CONVERGENCE ADJUSTMENT
Measuring
ItemTest pointAdjustment partDescription
instrument
CONVERGEN-SignalSERVICE SW (S801)1. Press the SERVICE SW S801 on the CONVERGENCE PWB
CE PHASEgenerator[CONVERGENCEto enter the dynamic adjustment mode.
adjustmentPWB]
2. Press the 100+ key on the remote control unit to select the
Remotegreen line.
control unit
3. Using the FUNCTION (2) (CH+) key, intentionally expand the
blinking horizontal green line as shown in the Fig. 1.
4. Press the SPLIT key on the remote control unit to enter the
Dynamic adjustment modePhase adjustment mode
phase adjustment mode.
5. Using the FUNCTION ( / ) key, adjust the screen so that the
AA Apoint ?A? is located between the cross-point of the dotted line
and the vertical line on the left side as shown in the Fig. 2.
6. Press the SPLIT key again to return to the dynamic adjustment
mode.
7. Press the 100+ key on the remote control unit to select the
green line.
Fig. 1Fig. 28. Return the point ?A?, which was intentionally expanded, to its
original position.
Dynamic adjustment mode9. Using the FUNCTION ( ) key, intentionally expand thePhase adjustment mode
vertical line as shown in the Fig. 3.
BB10. Press the SPLIT key to enter the phase adjustment mode.
11. Using the FUNCTION (2/1) key, adjust the screen so that the
peak of the point ?B? meets with the adjacent dotted line as
Bshown in the Fig. 4.
12. Press the SPLIT key again to return to the dynamic adjustment
mode.
13. Press the 100+ key to select the vertical green line. Then,
Fig. 3Fig. 4
using the FUNCTION ( ) key, return the point ?B?, which was
intentionally expanded, to its original position.
REMOTE CONTROL KEY POSITION
14. Press the SPLIT key again to enter the phase adjustment
mode.
15. Using the 2/5/4/6 key, adjust the screen so that the cross-point
of the dotted line is positioned at the screen center on the
screen. (Fig. 5)
SPLIT key16. Press the MUTING key and memorize the set value.
PHASE/DYNAMIC
Number key
Screen center
adjustment
100+ key
Select green line
Screen center
MUTING key
Store
FUNCTION key
Adjusting the line
Fig. 5
No. 5191439 |
ACEC
