AV-N65P74
1.2.2 INSTALLATION SITE
(1) The rear of this set is provided with ventilation openings.
Install the set more than 5 cm from a wall and in a location(more than 5cm)
with good ventilation.
(2) Avoid the following types of locations.
a) Unstable locations (location must be able to
withstand heavy weight).Wall
b) Locations subjected to direct sunlight.
c) Near stoves or other heating devices.
d) Locations subjected to humidity or oily smoke.
e) Dusty locations.
f) Locations with strong vibration.
VENTILATION OPENING
1.2.3 INSTALLATION ADJUSTMENT
When installing, moving or changing the orientation of the set,NOTE :
perform static convergence adjustment according to the? When you adjust the convergence, make sure you
following procedure.start with the center position (position 5), and work
Adjusting CRT color convergence have two method, AUTO,your way around radial for best results
MANUAL and RESET. It adjust on the MENU screen.? When you make the adjustment in the center
NOTE :(positions 5), you are making the adjustment for the
Please have you TV on for at least 20 minutes before sing thiswhale screen. In other positions, you are making the
feature.adjustment only in that area.
This adjustment will be needed only when the colors of the? You can reset the adjustment if you do not like the
characters/lines are separated and lack in distinction. If not,results, See below.
please don't perform the adjustment.? If you perform AUTO CONVERGENCE after
AUTOperforming MANUAL CONVERGENCE, your
(1) Press the [MENU] key, and select themanual convergence you performed will be
"CONVERGENCE" in the INITIAL SETUP menu with thecancelled.
[function up/down] key.(10) Press the [MENU] key to end the convergence
adjustment procedure.
(2) Press the [function left/right] key, then CONVERGENCERESET
menu appear.RESET in the CONVERGENCE menu resets all convergence
(3) Press the [function up/down] key, and select theadjustments to the factory default setting.
"AUTO".
(4) Press the [function left/right] key.
(5) he convergence adjustment will start. It will take about 50
seconds.
MANUAL
(1) Press the [MENU] key, and select the
"CONVERGENCE" in the INITIAL SETUP menu with
[function up/down] key.
(2) Press the [function left/right] key, the CONVERGENCE
menu appears.
(3) Press the [function up/down] key, and select theFig.1
"MANUAL".
(4) Press the [function left/right] key, then CONVERGENCE2
adjustment screen appear. [Fig.1]
? If all the crosses are white, no convergence
adjustment is needed.
(5) Select the location you want to adjust by using the465
[number (2/4/5/6/8)] keys on the remote control unit.
[Fig.2]
(6) Press the [SELECT] key to change the color of the box
to the color of the cross you want to adjust (red or blue).8
? You cannot adjust the green cross.Fig.2
(7) Use the [function up/down] key and the [function left/
right] keys to adjust the position of the cross.
(8) Adjust the three colors crosses until they overlap and
appear as a single white cross.
(9) Press the [OK] key.
(No.52126)1-7 |