EN35
Basic ConnectionsTape Dubbing
Make sure all units are turned off.Following the illustration on pg. 34, connect the
11camcorder and the VCR.
Connect the camcorder to a TV or VCR asSet the camcorderOs Power Switch to OPLAY�,
2shown in the illustration (Z pg. 34).2turn on the VCROs power, and insert the
If using a VCR . . . go to step 3.appropriate cassettes in the camcorder and the
If not . . . go to step 4.VCR.
Connect the VCR output to the TV input,Engage the VCROs AUX and Record-Pause
3referring to your VCROs instruction manual.3modes.
Turn on the camcorder, the VCR and the TV.Engage the camcorderOs Play mode to find a
44spot just before the edit-in point. Once it is
reached, press 4/6 on the camcorder.
Set the VCR to its AUX input mode, and set the
5TV to its VIDEO mode.Press 4/6 on the camcorder and engage the
5VCROs Record mode.
NOTES:Engage the VCROs Record-Pause mode and press
cIt is recommended to use the AC Power Adapter/64/6 on the camcorder.
Charger as the power supply instead of the battery
pack (Z pg. 9).Repeat steps 4 through 6 for additional editing,
cIf your VCR has an S-Video input connector,7then stop the VCR and camcorder when
connect the camcorder and the VCR using anfinished.
optional S-Video cable. This can improve the
dubbed picture quality.
cTo monitor the picture and sound from the
camcorder without inserting a tape, set the
camcorderOs Power Switch to OCAMERA� (OAUTO�
or OPRO.�), then set your TV to the appropriate
input mode.
cMake sure you adjust the TV sound volume to its
minimum level to avoid a sudden burst of sound
when the camcorder is turned on.
cIf you have a TV or speakers that are not specially
shielded, do not place the speakers adjacent to the
TV as interference will occur in the camcorder
playback picture. |