FS-SD58V_A1.fm Page 12 Thursday, September 28, 2000 4:49 PM
Using the Tuner
l Preset Tuning using the Unit
Press the PRESET TUNING + or - button to selectAuto Presetting
the desired preset number.
Its band and frequency are displayed.In each band, you can automatically preset FM-30, AM-15
English
stations. Preset numbers will be allocated as stations are
found, starting from the lowest frequency and moving up
the frequency.
? In AM broadcast, reception sensitivity will be changed by
turning the AM loop antenna. Turn the AM loop antenna
for best reception.FM / AMSET(for 2 seconds)
Presetting Stations
1Select a band by pressing the FM/AM
You can preset up to 30 FM stations and up to 15 AM sta-
button.
tions using the Remote Control.
2Press the SET button on the Remote
Control for more than two seconds.
? Preset numbers may have been set to factory test fre-
quencies prior to shipment. This is not a malfunction. You 3Repeat steps 1-2 for the other band.
can preset the stations you want into memory by following
one of the presetting methods below.o If you want to change the preset stations, carry out the
Manual Presetting for the desired preset numbers.
Manual Presetting
CAUTION:
SETSTORED
? Even if the system is unplugged or if the
FM / AMSETSET
power failure occurs, the preset stations
or
will be stored for about 24 hours. However,
When changing the BandFM = 30, AM = 15in case the preset stations are erased, you
will need to preset the stations again.
1Select a band by pressing the FM/AM
button.To Change the FM
Reception Mode
2Press the4 or c (DOWN or UP) but-
ton on the Unit or the Remote Control to
When you are tuned into an FM stereo broadcast, the
tune in a station.?STEREO? indicator lights up and you can hear stereo ef-
fects.
3Press the SET button.If an FM stereo broadcast is hard to receive or noisy, you
?SET? will blink for 5 seconds.can select Monaural mode. Reception improves, but you
Within 5 seconds, proceed to the next step.lose stereo effect.
When the display returns to the one set in step 2 after 5
seconds, press the SET button again.Press the FM MODE button on the Remote Control
so that the ?MONO? indicator lights up on the dis-
4Press the > or < button within 5 seconds
play.
to select the preset number.FM MODE
MPX
Pressing the > or < button will increase or decrease the
MONO
preset number by 1.
Pressing and holding the button will rapidly increase or
decrease the preset number.
To restore the stereo effect, press the FM MODE but-
5Press the SET button within 5 seconds.ton on the Remote Control so that the ?MONO? indicator
?STORED? appears and after 2 seconds, the goes off.display re-
turns to the broadcast frequency display.
6Repeat above steps 1 to 5 for each sta-
tion you want to store in memory with a
preset number.
To change the preset stations, repeat the same
steps as above.
12 |
ACEC
