3.1.5 Remove the switching regulator board (See figure 9)
SpacerSpacer
? Prior to performing the following procedure, remove the topSpacer Switching
CN5303CN5301CN5307
cover.regulator board
(1) Disconnect the card wire from connector CN5301 on the
switching regulator board.
(2) Disconnect the socket wire from connector CN5303,
CN5305, CN5306, CN5307 on the switching regulator
board.
(3) Disconnect the power cord from connector CN5001 on the
switching regulator board.
(4) Remove the two screws G attaching the switching regula-
tor board.
(5) Four spacers are removed.
GCN5001 G
CN5306
SpacerCN5305Power cord
Fig.9
3.1.6 Remove the main board (See figure 10, figure 11)
? Prior to performing the following procedure, remove the top
CN4001HCN3002CN3001
cover, drive unit, digital board, switching regulator board, HDD.
(1) Disconnect the card wire from connector CN3001,
CN3002, CN4001, CN7301 on the main board
(2) Remove the two screws H attaching the main board.
(3) Remove the seven screws I attaching the rear panel with
main board.
H CN7301 Main board
Fig.10
Rear panel
I
Fig.11
1-10 (No.YD027) |
ACEC
