3.1.5 Removing the tuner
(See Fig.8)CN1
? Prior to performing the following procedures, remove the rear
cover, bottom case (B) and top case assembly.
(1) From the right side of the main body, disconnect the card
wire from the connector CN1 on the tuner.
Card wire
Tuner
Fig.8
3.1.6 Removing the function board
(See Fig.9)
? Prior to performing the following procedures, remove the rear
CN951
cover, bottom case (B) and top case assembly.Digital amplifier
(1) From the top side of the main body, disconnect the fan mo-boardG
tor wire from the connector CN942 on the function board.Spacer
Tie bandWire
(2) Disconnect the wires from the connectors CN893 and
CN942
CN895 on the function board.CN895
(3) Remove the spacer and tie band fixing the wire.CN310
(4) Disconnect the wire from the connector CN310 on the dig-
ital amplifier board.
(5) Remove the three screws G attaching the function board.
(6) Lift the function board in the direction of the arrow and dis-G
connect it from the connector CN951 on the digital amplifier
board.
Reference:
When connecting the fan motor wire, put it through the slit e ofSlit e
the function board.Wire
Fan motor
G
CN893Function board
Fan motor wire
Fig.9
3.1.7 Removing the micon board
(See Fig.10)
? Prior to performing the following procedures, remove the rear
Wire
cover, bottom case (A), bottom case (B) and top case assem-Fanction board
bly.Micon boardTie bands
CN805
(1) From the right side of the main body, remove the tie bandsCN893
bundling the wires.
(2) Disconnect the wire from the connector CN805 on the mi-
con board.
H
(3) Disconnect the card wires from the connectors CN661 andH
CN871 on the micon board.
(4) Disconnect the wire from the connector CN893 on the func-
tion board.
(5) Remove the two screws H and two screws J attaching the
J
micon board.
(6) Pull the micon board toward this side, disconnect the con-
CN801
nectors CN801 and CN802 on the micon board.CN802JCN871
CN661
Reference:
Card wireCard wire
? After connecting the card wire to the connector CN661 on
Fig.10
the micon board, bend it as was done before disassembly
and insert it inside the center chassis.
? After connecting the wires to the connectors (CN805,
CN893) on the micon and function boards, bundle the wires
with the tie bands.
1-10 (No.MB044) |
ACEC
