3.1.10 Removing the regulator board
(See Fig.15)Regulator board
? Prior to performing the following procedures, remove the rear
cover, bottom case (A), bottom case (B), top case assembly,
tuner unit, function board, micon board, digital amplifier board
and power supply board.
(1) From the side of the power supply board, remove the two
screws Q attaching the regulator board.
(2) Disconnect the regulator board from the connector CN931QQ
on the power supply board in the direction of the arrow.
Power supply boardCN931
Fig.15
3.1.11 Removing the FL board
(See Fig.16)
? Prior to performing the following procedures, remove the rearFL board
cover, bottom case (B) and top case assembly.
(1) From the top side of the main body, disconnect the cardEngagement
wire from the connector CN751 on the FL board.section g
(2) Remove the screw R attaching the FL board.
(3) Release the two engagement sections g of the bottomCN751
chassis, take out the FL board.
R
Card wire
Engagement
section g
Fig.16
(No.MB009)1-13 |
ACEC
