2.8 TAKE OUT CASSETTE TAPE
NOTE :(4) Apply DC 3V to the electrode on the top surface of the
The following procedure describes a simplified method ofLOADING MOTOR ASSEMBLY to set the MECHANISM
ejecting the cassette tape in case it is not possible to eject it,ASSEMBLY to the EJECT mode.
due to an electrical failure.Unloading end is EJECT mode.
Be careful not to damage any of the parts or the tape when per-(5) If there is any slack tape in the tape transport system, wind
forming repairs or maintenance work.it inside the DVC CASSETTE TAPE by turning the REEL
(1) Remove the Power Unit (battery, DC code, etc.) from theDISK ASSEMBLY (SUP) from the backside of the SLIDE
set.DECK ASSEMBLY.
(2) Open the CASSETTE COVER.(6) Peel off the PVC TAPE and take out the DVC CASSETTE
(3) Attach a piece of PVC TAPE at the front of the CASSETTETAPE from the CASSETTE HOUSING ASSEMBLY.
HOUSING ASSEMBLY.NOTE:
NOTE:Make sure that grease or a similar substance is not at-
This helps prevent the tape from being damaged whentached to the surface of the tape.
the CASSETTE HOUSING ASSEMBLY is moved up-Similarly, also make sure that grease or a similar sub-
ward at the unloading end.stance is not attached on the MECHANISM ASSEMBLY.
(DC3V)
CASSETTE COVER
LOADING MOTOR
ASSEMBLY
REEL DISK ASSEMBLY (SUP)
PVC TAPE
CASSETTE HOUSING
ASSEMBLY
Fig.2-8-1
(No.86733)1-17 |
ACEC
