Preliminary
2.8 TAKE OUT CASSETTE TAPE
NOTE :(4) Apply DC 3V to the electrode on the top surface of the
The following procedure describes a simplified method ofLOADING MOTOR ASSEMBLY to set the MECHANISM
ejecting the cassette tape in case it is notA@possible to ejectASSEMBLY to the EJECT mode.
it, due to an electrical failure.Unloading end is EJECT mode.
Be careful not to damage any of the parts or the tape when per-(5) If there is any slack tape in the tape transport system, wind
forming repairs or maintenance work.it inside the CASSETTE TAPE by turning the REEL DISK
(1) Remove the Power Unit (battery, DC code, etc.) from theASSEMBLY (SUP) from the backside of the SLIDE DECK
set.ASSEMBLY.
(2) Open the CASSETTE HOLDER COVER.(6) Peel off the PVC TAPE and take out the CASSETTE TAPE
(3) Attach a piece of PVC TAPE at the front of the CASSETTEfrom the CASSETTE HOUSING.
HOUSING.Note:
Note:Make sure that grease or a similar substance is not at-
This helps prevent the tape from being damaged whentached to the surface of the tape.
the CASSETTE HOUSING ASSEMBLY is moved up-Similarly, also make sure that grease or a similar sub-
ward at the unloading end.stance is not attached on the MECHANISM ASSEMBLY.
(DC3V)
REEL DISK ASSY (SUP)
PVC TAPE
Fig.2-8-1
(No.86722)1-17 |
ACEC
