2.6 MECHANISM ADJUSTMENTS
2.6.1 Adjustment of the slide guide plate
Use Fig. 2-6-1 as the reference unless otherwise specified.
1. Set the PLAY mode.
See Fig. 2-3-8.
2. Loosen the screws ( A , B ).
3. With the Main Deck and Slide Deck Assemblies pushed
into the unit, tighten the screws ( A , B ) while applying
pressure to the stud (shaft) on the Slide Guide plate.
The pressure applied should be enough to enable utili-
zation of the rebounding force of the springs.
The tightening torque should be 0.069 NYm (0.7 kgfYcm).
4. Check the operation.
Repeat unloading and loading several times and make
sure that these operations can be performed smoothly
without producing rattles.
333
2, 3
SCREWA
2,3
SCREW B
3
STUD
(SHAFT)
3
Fig. 2-6-1
2-15 |
ACEC
