2.2 DISASSEMBLY/ASSEMBLY OF MECHANISM
ASSEMBLY
2.2.1General statementshift the mechanism mode from the STOP mode to the EJECT
The mechanism should generally be disassembled/assem-mode after the mechanism is removed from the main body.
bled in the EJECT mode (ASSEMBLY mode). (Refer to Fig.In such the case, supply 3 V DC to the electrode on the top
2-2-1.)of the loading motor to enter the mechanism mode into the
However, when the mechanism is removed from the mainEJECT mode.
body, it is set in the STOP mode. Therefore, it is required to
<Mechanism assembly/Cassette housing assembly><Back side of the mechanism assembly>
DC3V
�+
Motor
Back side of deck
EJECT mode
Fig. 2-2-1
2.2.2Explanation of mechanism mode
The mechanism mode of this model is classified into sixRefer to Fig. 2-2-2 to 2-2-7 below.
modes as shown in Table 2-2-1. Each mechanism mode canThe EJECT mode, C IN mode and SHORT FF mode should
be distinguished from others by the relative position of O�be recognized by the relative position of the O� mark to the
mark on the sub cam gear to the inner or outer protrusioninner protrusion, while the STOP mode, REV mode and PLAY
on the main deck.mode should be recognized by that to the outer protrusion.
<EJECT mode><C IN mode><SHORT FF mode>
Fig. 2-2-2Fig. 2-2-3Fig. 2-2-4
<STOP mode><REV mode><PLAY mode>
Fig. 2-2-5Fig. 2-2-6Fig. 2-2-7
2-2
ACEC
