7. 7a Loading brake assembly/ 7b Guide pin (S)Note 7a:
DonOt remove these parts unreasonably. If they are removed
7c Pad arm assembly/ 7d Slide guide plate assembly
for some reason, be very careful not to lose them.
7e Collar/ 7f Collar/ 7g Sub brake assembly
7h Control plate assemblyNote 7b:
When reinstalling the sub brake assembly, set the control
Note 7dplate assembly so that its hook is set in the part of the
(W7)sub brake assembly.
(P7b)7c
11
10Note 7c
(S7b)
(S7a)Note 7b
7d
(W7)
7b
7g
(P7a)
(W7)(P7c)
7e
7aNote 7c:
7f
Since the slide guide plate assembly controls the slide deck
Note 7b
Note
Note 7eassembly so that it exactly slides the main deck assembly, it
7amust exactly be assembled in the PLAY mode. Therefore,
(W7)
(P7d)(W7)temporarily fix the slide guide plate assembly in this stage.
For details of reassembling procedure, refer to O2.6.1
Assembling slide deck assembly and main deck as-
(L7b)
7hsembly� .
Note 7d:
(L7a)
The pad arm assembly controls the tension level of the
tension arm assembly. For adjustment of the tension arm
assembly, refer to O2.6.2 Locating tension pole�.
(L7d)(L7c)
Note 7e:
When reinstalling the loading brake assembly, slightly lift
Fig. 2-4-11the slide deck assembly upwards because the lower part
of the loading brake assembly sticks out of the slide deck
assembly.
8. 8a Tension lever assembly/ 8b Slide lever assembly
8c Brake control lever assembly
Note 8a, 8b, 8c:
For refitting the respective parts, refer to the following fig-
ures
Note 8c
8a
8a Tension lever assembly8b Slide lever assembly
8c
8b
Note 8a
Note
8b
8c Brake control lever
assembly
Fig. 2-4-12
2-11 |
ACEC
