1.4 DISASSEMBLY/ASSEMBLY OF 5 MONITOR ASSY1.4.2 HINGE ASSY
1. Remove the two screws (4,5) to take out the FPC ASSY
1.4.15 MONITOR ASSY/HINGE ASSY
while removing the HINGE COVER (L).
1. Remove the three screws (1 to 3) and then remove the
monitor cover by disengaging the two hooks (L5a, L5b)NOTE5c:Be careful not to lose any part during the above-
at the top and bottom.mentioned process.
NOTE5a:Be careful not to lose part (Rib).2. Remove the HINGE COVER (U) from HINGE ASSY.
2. Pull out the part (sensor) from the MONITOR CASE ASSY.3. Remove the FPC ASSY from the HINGE ASSY.
3. Release the lock of the connector CN5a. Disengage theNOTE5d:Be careful not to lose any part during the abobe
two hooks (L5c, L5d) to remove the HINGE ASSY frommentioned process.
MONITOR CASE ASSY, then remove the FPC from theNOTE5e:When reassembling, wind the FPC ASSY around
HINGE ASSY.
the HINGE ASSY by three turns and a half.
NOTE5b:When removing the parts out of the MONITORBe careful not to break the FPC wire during the
CASE ASSY, be very careful not to damage thework.
FPC and parts.
4. Take out the LCD MODULE, BACK LIGHT and MONI-
TOR BOARD ASSY from the MONITOR CASE ASSY. Be
careful with the hooks (L5e, L5f) on the two sides.
Disconnect the FPC ASSY from the connector (CN5b)
and remove the LCD MODULE. Be careful with the hooks
(L5g ,L5h) on the two sides.
MONITOR
CASE ASSY
* : 0.058 NYm (0.6 kgfYcm)
b
5a(Lf)
BACK LIGHT
(L5 e)
(L5 h)
LCD
NOTE5eMODULE
MONITOR
FPC ASSY(L5 g)BOARD ASSY
MONITOR
COVER
CN5 c
HINGE
(L5 a)3
COVER(L)c
CN5 a(S5 a)
SENSORCN5 b5
NOTEa
HINGEcRIBa
ASSY
(L5 d)1
(S5 a)
b*
NOTE5d42
HINGE(S5 c)(S5 a)
(L5 b)
ASSY
HINGE
(L5 c)
COVER(U)
*NOTE5c
5
MAGNET5
(Sc)
NOTE5c
MARKING
FPC ASSY
NOTE5b,d,e,f
Fig. 1-4-1
1-8 |
ACEC
