HOW TO USEHOW TO USE
How to use the speakers
5. Push the AUTO TUNING switch control to get the best reception in the
speakers.
1. Connect the transmitter and AV equipment. (Refer to page 10)
When the button is pressed, frequency tuning starts automatically and it stops
2. Connect the AC adaptor to the transmitter, then plug the AC adaptor into an AC
when a signal is detected.
outlet. (Refer to page 11)
3. Turn on the power on the transmitter and the connected AV equipment.
In cases of interference or
too much noise, turn the
TUNING control on the
transmitter to another
position, then repeat step 5.
AUTOTUNING
SST
6. Press the BASS BOOST (BOOST
BASS) button when the bass is not
enough. The bass can be emphasized.
Transmitter power
When an audio signal is input, the transmitter's power is turned on automatically, and the
indicator lights in green. Also, when no audio signal is input for about a minute, the
indicator goes out automatically and the power turns off. (Automatic Power On/Off function)
In some situations, the power may not be turned on automatically by the input sound (e.g. a
song with a quiet opening or gradual fade-in). This is not a malfunction.
NORMALBOOSTBASS
4. Turn the knob clockwise to turn on the
speaker power and to control the
After use
volume.
Turn the knob counterclockwise until the click sound is heard to turn off the speaker
power. The red light of the power indicator goes out.
(OFF) MIN.MAX.
VOLUME
HA-RF100S(J)
2021
13 |
ACEC
