CD-2260M/DPF(K) COVER( 98.4.24 10:51 PM y[W 3
CD-2260M/2280M/DPF-J7010/J9010
CONTENTS / ACCESSORIES
Contents
CONTENTS / ACCESSORIES ...................................2PC BOARD ...............................................................11
EXTERNAL VIEW .......................................................3SCHEMATIC DIAGRAM ...........................................15
DISASSEMBLY FOR REPAIR ....................................4EXPLODED VIEW ....................................................26
CONTROLS ................................................................5PARTS LIST..............................................................28
CIRCUIT DESCRIPTION............................................7SPECIFICATIONS ......................................Back cover
ADJUSTMENT ..........................................................10
Accessories
Audio cord.......................(1)System control cord........(1)Communication cord.......(1)
(E30-0505-05)(E30-2816-05)(E30-2861-05)
Remote control unit........(1) *Batteries (R6/AA)............(2)
(A70-1174-08) : RC-P0506
(A70-1175-08) : RC-P0306
Battery cover (A09-0374-08)* Refer to parts list on page 28.
Beware of condensationBeware of condensation
When water vapor comes into contact with the surface of coldBe especially careful in the following conditions:
material, water drops are produced.Y When the unit is brought from a cold place to warm place, and
If condensation occurs, correct operation may not be possible,there is a large temperature difference.
or the unit may not function correctly.Y When a heater starts operating.
This is not a malfunction, however, and the unit should be dried.Y When the unit is brought from an air-conditioned place to a
(To do this, turn the POWER switch ON and leave the unit as itplace of high temperature with high humidity.
is for several hours.)Y When there is a large difference between the internal tempera-
ture of the unit and the ambient temperature, or in conditions
where condensation occurs easily.
Note related to transportation and movementOperation to reset
The microcomputer may malfunction (impossibility to operate,
Before transporting or moving this unit, carry out the following op-erroneous display, etc.) when the connection cords are un-
eration:plugged while power is ON or due to an external factor. In this
case, execute the following method to reset the microcomputer
1. Remove all discs from the carousel and close the door panel.and return it to normal condition.
2. Confirm that the flashing ONO DISC� display has changed to steady
lighting, and then switch off the power.Unplug the power cord from the power socket and plug the
power cord into the socket again.
NOIDCS
To reset the registered contents
3. Wait a few seconds, then disconnect the power plug.
The registered contents for title name, music type, and best
selection can be reset by the following procedure.
Unplug the power cord from the power socket and, while
holding the 7 key depressed, plug the power cord into the
socket again.
2 |
ACEC
