DP-3080Mk2(k) COVER( 98.4.24 2:42 PM y[W 3
DP-3080MkII/3090
CONTENTS / ACCESSORIES / CAUTIONS
Contents
CONTENTS / ACCESSORIES / CAUTIONS.............2SCHEMATIC DIAGRAM ............................................7
DISASSEMBLY FOR REPAIR ..................................2EXPLODED VIEW ..................................................12
CIRCUIT DESCRIPTION ..........................................3PARTS LIST..............................................................14
ADJUSTMENT ...........................................................4SPECIFICATIONS....................................................17
PC BOARD ...............................................................5
Accessories
Audio cord...........................................(1)Batteries (R6/AA)................................(2)Remote control unit..........................(1)
(E30-2841-08)(A70-1181-08) : RC-P03050
RC-P0505
REMOTE CONTROL UNIT
Battery cover (A09-0356-08)
System control cord..........................(1)AC plug adaptor.................................(1)
(E30-2629-05)(E40-9981-08) M type only
Cautions
Note related to transportation and movement
Before transporting or moving this unit, carry out the followingTRACK12345
operations.6789 10
1. Turn the power ON but do not load a disc.11 12 13 14 15
2. Verify that the display shown appears. no d sc116 17 18 19 20
3. Wait a few seconds and set the unit to STANDBY mode.
Beware of condensationBe especially careful in the following conditions:
When water vapor comes into contact with the surface of cold? When the unit is brought from a cold place to a warm place, and
material, water drops are produced.there is a large temperature difference.
If condensation occurs, correct operation may not be possible, or? When a heater starts operating.
the unit may not function correctly.? When the unit is brought from an air-conditioned place to a place
This is not a malfunction, however, the unit should be dried.of high temperature with high humidity.
To do this, turn the ON/STANDBY switch ON and leave the unit? When there is a large difference between the internal temperature
as it is for several hours.of the unit and the ambient temperature, or in conditions where
condensation occurs easily.
DISASSEMBL Y FOR REPAIR
How to remove the CD tray.21
14
H Remove the CD mechanism from unit before this step.
1. Remove the 2 screws (1), then remove the clamper
fram.
2. Turn the gear (2) under the tray, then remove the tray6
on the position A (3).
3. Remove the guide frame (4), then remove the collar of
the leaf switch in the left direction (5).
7
4. While raising the click on the left-rear side of the tray (6),
3position
pull out the tray (7). "A"
CP401
CP201
5
2 |
ACEC
