DPX-3070/3070B
TEST MODE
I How to enter the test mode Y The settings for Q, Feq, and Ex are fixed.
Y In order to enter the test mode, while pressing down [ATT]
Q2.0
+ [WOW] keys simultaneously, press [SRC] key.
BassFeq150Hz
I Test mode conditionsExtON
Y The test mode starts up when STANDBY source is selected.Q2.0
Mid
Y The volume value is �10dB. (30 on the display)Feq1kHz
Y Beep prohibited.
Y All lights displayed. (3-color LED lights up for all three col-TrebleFeq10kHz
ors. (white lighting))
Y WOW : OFFI Test mode (Audio adjustment)
Y While the source is being displayed, long-clicking on the
Y EQ : Natural
[EQ/AUD] key will cause the unit to enter Adjustment Mode.
By toggling on the [FM] and [AM] key, the items below can
I Test mode (Source : CD)
Y When starting disc loading, tracks will be played startingbe selected and adjustments can be made with [] and
[ ] keys.
with the Track No. 9.
Y The key operations below will be conducted only when theThe balance adjustment is set for three steps
: RIGHT ? CENTER ? LEFT (L15, R15)
source is CD.The fader adjustment is set for three steps
Even when changes occur in the track number being played
with the other sources, the play condition will persist.: FRONT ? CENTER ? REAR (F15 and R15)
Preset [1] key for Track No. 19
Preset [2] key for Track No. 5I Test mode (DC offset detection)
Y When DC error detection is carried out during the Test Mode,
Preset [3] key for Track No. 15
Preset [4] key for Track No. 14the unit shuts down without writing the error information to
the EEPROM. The other cases will be the same as the DC
Y[ ] key is to be used for selecting preset tracks only. (Re-
fer to the table below.)offset specifications.
Y[ ] key is to be used for down selection, as with regular
operation.I Test mode (Display of DC offset detection results)
Y When in this mode, the mode for ODisplay of DC offset de-
Current trackTrack to be searchedtection results� will be added in the MENU items at the time
No. 1~No. 8, No. 14, No. 16~MaxNo. 9when Test Mode Standby is the source. This will make it
possible to confirm results with presence-or-absence de-
No. 9No. 15
tection.
No. 15No. 10MENU selection : DIMMER adjustment ? ? ? (NAVI ATT
No. 10No. 11
ON/OFF) ? (CODE STBY) ? Display of DC offset detec-
No. 11No. 12tion results
No. 12No. 13 Y Display
DC offset detected : DC Err
No. 13No. 14
DC offset not detected : DC OK
I Test mode (EQ adjustment)3 The detection information in the EEPROM can be forcibly
Y While the source is being displayed, clicking once on the
cleared by pressing [] or [] key for more than two
[EQ/AUD] key will cause the unit to enter Adjustment Mode.seconds while the DC offset detection (DC Err) is being
When [1] key is pressed: Flat
When [2] key is pressed : Full-boostdisplayed. In this case, the display will be for DC offset not
detected. (DC OK).
When [3] key is pressed : Full-cut
8 |
ACEC
