DV-402/DVF-3530/3530-S
CONTENTS / ACCESSORIES / CAUTIONS
Contents
CONTENTS / ACCESSORIES / CAUTIONS............. 2PC BOARD ................................................................ 7
DISASSEMBLY FOR REPAIR....................................3SCHEMATIC DIAGRAM .......................................... 11
BLOCK DIAGRAM ......................................................4EXPLODED VIEW ....................................................19
WIRING DIAGRAM .....................................................5PARTS LIST..............................................................20
WAVEFORM ...............................................................6SPECIFICATIONS ......................................Back cover
Accessories
Audio video cord (1)Optical fiber cable (1)
(Red, White, Yellow) (For U.S.A. only)*AC plug adaptor (1)
(E30-2990-08)(E30-2989-08)(E03-0115-05)
* Use to adapt the plug on the
power cord to the shape of the
wall outlet.
(Accessory only for regions
where use is necessary.)
Remote control unit (1)Batteries (R03/AAA) (2)
(A70-1482-08)
Cautions
Note related to transportation and move-Beware of condensation
mentWhen the difference between the internal temperature of the unit
and external atmosphere is large, dew (mist) may be produced on
Before transporting or moving this unit, carry out the follow-
ing operations.the internal parts of the unit. In such a case, turn the unit ON and
1. Set the POWER key to ON without loading a disc.leave it for a few hours until the condensation has dried up.
2. Wait a few seconds and verify that the display shown
appears.Be especially careful in the following conditions:
3. Set the POWER key to OFF.When the unit is brought into a place where there is a large differ-
ence in temperature between the previous location, when the
humidity of the listening room is high, etc.
Operation to reset1 In POWER ON condition, keep the 7 (STOP) key and the
The microprocessor may fall into malfunction (impossibility to oper-ON/STANDBY key pressed at the same time.
2 When both keys are pressed, the region code of the unit, the
ate erroneous display, etc.) when the power cord is unpluggedsoftware version, etc. will be displayed on the display. (When
while power is ON or due to an external factor. In this case, exe-nothing is done, the display of this information continues.)
cute the following procedure to reset the microprocessor and
return it to normal condition.Example: 71 . 101 . 06:14
3 Press the ON/STANDBY key to go to STANDBY mode.
4 When Power ON is performed with the ON/STANDBY key,
the settings become the default factory settings.
? Please note that resetting the microprocessor clears the con-
tents stored in, it returns the microprocessor to the condition
when it left the factory.
2 |
ACEC
