DV-705/DVF-R5070-S
ACCESSORIES / CAUTIONS
Accessories
Audio video cord (Red, White, Yellow) ...(1)Remote control unit ...(1)Batteries(R6/AA) ...(2) Coaxial cable ...(1)
(E30-2990-08) (A70-1570-08)(E30-7235-08)
Cautions
Operation to reset
During stop mode, press the MENU key on the remote to
The microprocessor may fall into malfunction (impos-enter "Control Panel" menu.
sibility to operate erroneous display, etc.) when theSelect the "System" icon, then press the Cursor right ( ) key.
power cord is unplugged while power is ON or due toSelect "Restore Setup Info".
an external factor.Press the numeric keys as shown below.
In this case, switch off the power, wait for several sec-Press , , , , then press the ENTER key.
onds, and then switch the power on again.When resetting is done according to this method, all settings,
Return to the factory defaults by resetting the micropro-including the settings for password and parental level, will be
cessor is done as shown as follows.reset to the factory defaults.
Note related to transportation and movementCaution on condensation
Before transporting or moving this unit, carry out theCondensation (of dew) may occur inside the unit when there is a great
following operations.difference in temperature between this unit and the outside. This unit
1. Set the POWER ON/OFF switch to the ONmay not function properly if condensation occurs. In this case, leave
without loading a disc.the unit for a few hours and restart the operation after the condensa-
2. Wait a few seconds and verify that the displaytion has dried up.
shown appears.
Be specially cautious against condensation in the following circum-
stances:
When this unit is carried from one place to another across a large
difference in temperature, when the humidity in the room where
3. Set the POWER ON/OFF switch to OFF.this unit is installed increases, etc.
The marking of products using lasers
(For countries other than U.S.A. and U.S.-Military)
CAUTION
VISIBLE AND INVISIBLE LASER RADIATION
CLASS 1WHEN OPEN. DO NOT STARE INTO THE BEAM OR
LASER PRODUCTVIEW DIRECTLY WITH OPTICAL INSTRUMENTS.
DO NOT PRESS ON THIS SURFACE
The marking this product has been classified as Class 1. ItInside this laser product, a laser diode classified as Class 2 laser radia-
means that there is no danger of hazardous radiation outsidetion is contained as alerted by the internal caution label shown above. Do
the product.not stare into beam or view directly with optical instruments.
Location: Back panelLocation: DVD laser pick-up unit cover inside this product
Manufactured under license from Dolby Laboratories.CAUTION:
Use of controls or adjustments or performance of procedures other than
"Dolby" and the double-D symbol are trademarks of Dolbythose specified herein may result in hazardous radiation exposure.
Laboratories.
In compliance with Federal Regulations, the following are reproductions
of labels on, or inside the product relating to laser product safety.
"DTS" and "DTS Digital Out" are trade-KENWOOD CORPORATION
marks of Digital Theater Systems, Inc.2967-3, ISHIKAWA-CHO,
HACHIOJI-SHI,
TOKYO, JAPAN
KENWOOD CORP. CERTIFIES THIS EQUIPMENT
CONFORMS TO DHHS REGULATIONS NO. 21 CFR
1040.10, CHAPTER 1, SUBCHAPTER J.
Location: Back Panel
CAUTION-LASER RADIATION WHEN OPEN.
DO NOT STARE INTO BEAM.
Location: Laser Pick-up Unit Cover inside this product
2 |
ACEC
