DVR-6200
ACCESSORIES / CAUTIONS
Accessories
FM indoor antenna (1)Loop antenna (1)Video cord (1)Speaker cords (6)
(T90-0882-08): MEX(T90-0896-08)(E30-1427-05)(E30-5480-08): RD
(T90-0907-08): K(E30-5962-08): WH
(E30-7005-05): VT
(E30-5482-08): GN
(E30-5483-08): GY
(E30-5963-08): BL
Remote control unit (1)SCART plug adaptor (1)Batteries (R6/AA) (2)
(A70-1647-08): KXM(Europe only)
(A70-1648-08): E(E69-0012-05)
SYSTEM CONFIGURATION
SYSTEMMAIN UNITSPEAKER
DVT-6200DVR-6200KSW-6200
Cautions
Speaker model names
SystemSpeakers
DVR-6200KSW-6200 (Left speaker, right speaker, center speaker, surround speakers and subwoofer)
Note related to transportation and movementCaution on condensation
Before transporting or moving this unit, carry out theCondensation (of dew) may occur inside the unit when there is a great
following operations.difference in temperature between this unit and the outside. This unit
may not function properly if condensation occurs. In this case, leave
1.Set the POWER ON/OFF switch to theON
without loading a disc.the unit for a few hours and restart the operation after the condensa-
2. Wait a few seconds and verify that the displaytion has dried up.
shown appears.
Be specially cautious against condensation in the following circum-
stances:
When this unit is carried from one place to another across a large
difference in temperature, when the humidity in the room where
3. Set the POWER ON/OFF switch to OFF.this unit is installed increases, etc.
Manufactured under license from Dolby Laboratories.
ODOLBY�, OPro Logic� and the double-D symbol areODTS� and ODTS Digital Surround� are trademarks of
trademarks of Dolby Laboratories.Digital Theater Systems, Inc.
The marking of products using lasers
(For countries other than U.S.A. and U.S.-Military)
CAUTION
VISIBLE AND INVISIBLE LASER RADIATION
CLASS 1WHEN OPEN. DO NOT STARE INTO THE BEAM OR
LASER PRODUCTVIEW DIRECTLY WITH OPTICAL INSTRUMENTS.
DO NOT PRESS ON THIS SURFACE
The marking this product has been classified as Class 1. ItInside this laser product, a laser diode classified as Class 2 laser radia-
means that there is no danger of hazardous radiation outsidetion is contained as alerted by the internal caution label shown above. Do
the product.not stare into beam or view directly with optical instruments.
Location: Back panelLocation: DVD laser pick-up unit cover inside this product
Operation to reset
1Press the MENU key on the remote to enter SETUP
The microprocessor may fall into malfunction (impos-MENU.
sibility to operate erroneous display, etc.) when the2Select the PREFERENCE, then press the ENTER key.
power cord is unplugged while power is ON or due to3Select DEFAULTS, press the Cursoe right (3) key to
an external factor.select RESET.
In this case, switch off the power, wait for several sec-4Press the numeric keys as shown below.
onds, and then switch the power on again.Press 1 , 3 , 9 , 7 , then press the ENTER key.
Return to the factory defaults by resetting the micropro-When resetting is done according to this method, all set-
cessor is done as shown as follows.tings, including the settings for password and parental level,
will be reset to the factory defaults .
2 |
ACEC
