5050-001
ProblemAction
Toner adheres to the back of the Remove the fuser coating roll from under
page.the printer?s rear cover, and wipe it with a
dry, lint-free cloth. If you still have the
problem, go to ?Periodic Dirt? on
page 2-44.
Quality of printed transparencies Be sure you?re using the recommended
is inadequate.Lexmark transparencies.
Be sure you?re loading transparencies
properly.
When printing transparencies, always set
the Paper Type to Transparency.
Set the Color Correction menu item to
Vivid.
Avoid getting fingerprints on
transparencies before printing.
Print on the page is skewed.Be sure the width guides in the paper tray
or the multipurpose feeder fit snugly
against the media you loaded.
Be sure the paper you load in the trays
fits under the two corner tabs at the front
of the tray.
A white gap is noticeable Be sure all four corners of the printer are
between color fills, due to poor resting on a level surface.
color registration.
Turn the printer off and back on. The
printer calibrates the photoconductors
and drive gears, which may improve
registration.
If the Printer Usage menu item is set to
Maximum Yield, make sure the Timing
Adjustment menu item is set to Gear and
Drum.
Diagnostic Information2-41 |
ACEC
