ADJUSTMENT INSTRUCTIONS
1. Application Object3-2. Channel memory Method
These instructions apply to the MF-056B Chassis.1) Select OPDP� and OHurricane� on Model dialog. And check
your connection in Communication dialog. (If your
connection is �NGO, then set your PORT(COM1,2,3,...)
2.Specificationcorrectly.)
(1) Because this is not a hot chassis, it is not necessary to use2) Connect RS-232C cable and turn on the power.
an isolation transformer. However, the use of isolation(If your connection has completed, you can see OReady�.)
transformer will help protect test instrument.
(2) Adjustment must be done in the correct order.[ If your set is not an end products but only a board, you
(3) The adjustment must be performed in the circumstance ofhave to make your board to Stand-by state (LED_R). And
25?5!C of temperature and 65?10% of relative humidity ifyou have to Download in Stand_by power state.
there is no specific designation.
(4) The input voltage of the receiver must keep 100-220V,
50/60Hz.
(5) The receiver must be operated for about 15 minutes prior
to the adjustment.
OAfter RGB Full white HEAT-RUN Mode, the receiver must
be operated prior to adjustment.
OEnter into HEAT-RUN MODE
1) Press the POWER ON KEY on R/C for adjustment.
2) OSD display and screen display 100% full WHITE
PATTERN.
[ Set is activated HEAT-RUN without signal generator in(Fig. 2)
this mode.
[ Single color pattern(RED/BLUE/GREEN) of HEAT-RUN
mode uses to check PANEL.3) Select proper CH_memory file(*.nvm) for each model at
[NVRAM Download] $ [Write Batch]
Caution) If you turn on a still screen more than 20 minutesNext, select proper binary file(*.bin) including the CH
(Especially digital pattern, cross hatch pattern), afterinformation for each model at [NVRAM File].
image may be occur in the black level part of the4) Click the [Download] button.
screen.It means the completion of the CH memory download if all
items show �OKO and Status is changed by �PASSO at the
lower right corner of the window.
3. Channel memory5) If you want to check whether the CH information is
memorized correctly or not, click the [Verify] button.
3-1. Setting up the LGIDSAnd then compare NVRAM File(*.bin) with the CH
1) Install the LGIDS. (idsinst.exe)information downloaded.
2) After installation, restart your PC.
3) Extract [files.zip] to folder [c:\LGIDS\files].
4) Start LGIDS.
(Fig. 3)
3-3 Sub program download
1) Select OPDP� and OHurricane� on Model dialog. And check
your connection in Communication dialog. (If your
connection is �NGO, then set your PORT(COM1,2,3,...)
correctly.)
(Fig. 1)
- 10 - |