14) Set Brightness and Contrast to Max position.5. Input EDID Data.
15) Set SUB-CONTRAST 200(C8) (decimal) position.1) Display color 15,0 cross hatch pattern at Mode 4.
16) Set B-DRIVE to 150(96) at DRIVE of the alignment 2) EEPROM ? Write EDID command and confirm
program.OEDID Write OK!!� message of monitor.
17-1)Adjust R-DRIVE and G-DRIVE command to white3) Exit from the alignment program.
balance x=0.283?0.003 and y=0.298?0.003 on the4) Power switch OFF/ON for EDID data save.
White Balance Meter with PC arrow keys.6. Adjustment for Focus.
17-2)Display color 15,0 window pattern (70x70mm) at mode 4.
18) Adjust SUB-CONTRAST command to 50?2FL .1) Set the Brightness and Contrast to max position.
2) Display H character in full screen at Mode 4.
19) After push the OENTER � key.3) Adjust two Focus control on the FBT that focus
20) Display color 15,0 full white patten at Mode 4..should be the best condition.
21) COLOR ADJ. ? LUMINANCE ? ABL command.
22) Adjust ABL to 32?1FL of the luminance.
23) After push the OENTER � key, and OCOMMAND ?
PRESET EXIT ? Y(Yes)� command.
24) Exit from the program.
- 11 - |
ACEC
