ADJUSTMENT
All adjustment are thoroughly checked and corrected
when the monitor leaves the factory, but sometimes2. Adjustment for White Balance
several minor adjustment may be required.1) Display color 0,0 pattern at Mode 13.
Adjustment should be following procedure and after2) Set External Bright to MAX position and Contrast to
warming up for a minimum of 10 minutes.MAX Position.
Alignment appliances and tools.3) Select PRESET START ? BIAS CAL command
and Enter.
- IBM Compatible PC
4) No attempt to manually adjust, BIAS data is auto-
- Programmable Signal Generator.
matically adjusted and saved to the EEPROM.
(eg. VG-819 made by Astrodesign Co.)
5) Display color 15,0 pattern at Mode 13.
- E(E)PROM with each mode data saved.
6) Select DRIVE CAL command and Enter.
- Alignment Adapter and Software.
7) Color 1 (9300K) and Color 2 (6500K) are
1. Adjustment for Factory Preset Modeautomatically adjusted and saved to the EEPROM.
1) Run alignment program for LM505F on the IBM8) Select PRESET END command and Enter.
compatible PC.
2) Select EEPROM All Init. command and Enter.3. DDC Data Write Procedure
3) Display cross hatch pattern at Mode 1.1) Use this procedure only when there is some
4) Select COMMAND PRESET START command.probelm on EDID data.
5) Select EDID WRITE command and Enter.2) Select EDID ? Write EDID[Aë] command and
6) Press OY�key, it will automatically save all FOS data Enter.
to EEPROM.3) This will write the EDID data to EEPROM.
A
IBM96
Video Signal
Compatible PC155111
Generator10
6
51
C
PARALLEL PORT
131
Not used2514
RS232COFFON
5V
CF
PARALLEL
Power inlet (required)5V
Control Line2204.7K
VGSPower Select SwitchON5V4.7K
POWER(110V/220V)
E
AMONITORSTPower LEDOFF4.7K74LS06
V-SYNC
74LS06
E ST Switch
B
B
F V-Sync On/Off Switch
(Switch must be ON.)
Figure 1. Cable Connection
- 9 - |
ACEC
