MINOLTA DI551 Repair Manual

0,3+,9=0*,Å�)662??Å�ů?Ã�?´??ĺDÃ�yD5Ã�y??
�ü
ISW

[3] Copying Transfer Data (Update Data)
Run the ISW Trns program to copy transfer dataStep Procedure
(update data) to the PC.8 Click Copy to copy the selected transfer files
(update data) to the folder created at ISW
Step ProcedureTrns setup.
1 Boot the PC.Note1: To copy all the files (update data)
displayed in the Original Files field,
2 Select ISW Trns from the Start menu to run click Copy All, instead of Copy.
the ISW Trns program.Note2: The folder name created at ISW
Trns setup is displayed above the
3 Click the Option menu.
Copied File field.
4 [Option window]Note3: The transfer files that have been
copied successfully so far are listed
in full-path name in the lower part of
the Copied File list view.
The transfer files that have not been
copied successfully are listed in the
Failed to Copy Files list view.
Causes of copy errors:
1. A file with the same name existed
and the O/W (overwrite) check
box was not checked.
Click Data Copy.2. The storage destination folder
5 [File Copy window]could not be found.
3. Attempted to overwrite an over-
write protected file.
Note4: To update existing transfer files
(update data), check the O/W (over-
write) check box.
9 When the copying completes, click Refresh.
Mount an update disk on the PC and click 10 If more update disks are involved, repeat
Browse.Steps 5 to 9.
6 Select the folder on drive A that contains the 11 Click Cancel to return to the option window.
transfer file (update data) as a source file.12 [Option window]
Note1: The selected folder is displayed inClick OK.
the upper section in the Original
Files field.
Note2: The transfer files (update data) that
are stored in the selected folder are
displayed in the lower section in the
Original Files field.
ISW
5 7 Select the transfer files (update data) you
want copied from the lower section in the
3 DIS./ASSEMBLYOriginal Files field.
Note1: You can select multipletransfer files
(update data).
Note2: To copy all the files (update data)
displayed, skip this step to go to
Step 8 directly.
5-12