DisassemblyC155
Removing and Replacing the Transceiver Board
1.Remove the front housing as described earlier.
2.Using a size T5 screwdriver, remove 4 screws from the transceiver board mounted in the
back housing.
Figure 9.
3.Pry open the side latches securing the transceiver board to the back housing and then
remove it.
4.To replace, mount the transceiver board in the back housing until the side latches snap
into place, and then secure it with four screws.
5.Restore the front housing and other parts.
Removing the Speaker Unit
1.Remove the transceiver unit as described earlier.
2.Disconnect the speaker wire from the transceiver board.
Figure 10.
19June 1, 2004 |
ACEC
