REMOTE CONTROL OPERATION
Programming The Remote
The Universal Remote Control can be programmed to operate many manufacturers? components, using the component
function buttons for VCR, DVD, CABLE or DBS. Follow the procedures for programming your Remote Control with or
without a code for the component.
Default Modes For Remote Control
DeviceOperatesDefault
TVTV (Panasonic Only)Panasonic TV Codes
VCRVCR (Preset)Panasonic VCR Codes
DBSDBS (Preset)Panasonic DBS Codes
CABLECABLE (Preset)Panasonic DBS Codes
DVDDVD, CD (Preset)Panasonic DVD Codes
Determine the manufacturer of the component and look in the table for the code.
Programming With a Code
Procedure
?Confirm that the external component is plugged in and operating.
?Turn the component off.
ACTION
POWER
?Pressandtogethfoerr,at least 5 seconds.
?Press appropriate component button on the Remote Control VCR, DVD, CABLE or DBS.
?Enter the 3-digit component code using the Remote Control numeric keypad (0 ~ 9 buttons).
?Press the Remote ControlPOWERto test the component. If the procedure was successful, the component will turn on.
Helpful Hints: Unsuccessful Code
If the component does not operate with the Remote Control, repeat
the procedure using another code. (Some brands have multiple
codes).
If an incorrect code is entered, or if the procedure takes longer than
30 seconds, the programming will fail.
Programming Without A Code
This procedure searches all codes and is called the ?sequence method.?
?Confirm that the external component is plugged in and on.
?Turn the component off.
ACTION
?PressandPOWERtogethfoerr,at least 5 seconds.
?Press appropriate component button on the Remote Control.
?PressVOL to move forward to the next code. PresVOLs to move backward.
?Press the Remote ControlPOWERto test the component. If the procedure was successful, the component will turn on.
Note: Repeat the above steps until the component code is found. It may take many attempts before the correct code
is found.
ACTION
?After the code is found, pressto store the code.
12 |