DISASSEMBLY INSTRUCTIONS
1. REMOVAL OF ANODE CAPINSTALLATION
Read the following NOTED items before starting work.1. Clean the spot where the cap was located with a small
amount of alcohol.
* After turning the power off there might still be a potential
voltage that is very dangerous. When removing the
Location of Anode Cap
Anode Cap, make sure to discharge the Anode Cap's
potential voltage.
* Do not use pliers to loosen or tighten the Anode Cap
terminal, this may cause the spring to be damaged.
REMOVAL
1. Follow the steps as follows to discharge the Anode Cap.
Connect one end of an Alligator Clip to the metal part of a
flat-blade screwdriver and the other end to ground.
While holding the plastic part of the insulated Screwdriver,
touch the support of the Anode with the tip of theNOTE
Screwdriver.Confirm that there is no dirt, dust, etc. at the spot where
A cracking noise will be heard as the voltage is discharged.
the cap was located.
2.Arrange the wire of the Anode Cap and make sure the
wire is not twisted.
3.Turn over the Rubber Cap.GND on the CRT
4. Insert one end of the Anode Support into the anode button,
then the other as shown in the figure below.
ScrewdriverCRT
Support
Alligator Clip
GND on the CRT
2.Flip up the sides of the Rubber Cap in the direction of theSupport
CRT
arrow and remove one side of the support.
5.Confirm that the Support is securely connected.Rubber Cap
6.Put on the Rubber Cap without moving any parts.
2. NOTE FOR THE REMOVAL OF THE
MAIN PCB
When the removal of the Main PCB, remove the hook
first, then draw it in the direction of the arrow.
CRT
Support
3. After one side is removed, pull in the opposite direction to
remove the other.
NOTE
Take care not to damage the Rubber Cap.
B-1 |
ACEC
