A-307R, A-207R
1. SAFETY INFORMATION
This service manual is intended for qualified service technicians ; it is not meant for the casual do-it-
yourselfer. Qualified technicians have the necessary test equipment and tools, and have been trained
to properly and safely repair complex products such as those covered by this manual.
Improperly performed repairs can adversely affect the safety and reliability of the product and may
void the warranty. If you are not qualified to perform the repair of this product properly and safely, you
should not risk trying to do so and refer the repair to a qualified service technician.
WARNING
Lead in solder used in this product is listed by the California Health and Welfare agency as a known reproductive toxicant which may
cause birth defects or other reproductive harm (California Health & Safety Code, Section 25249.5).
When servicing or handling circuit boards and other components which contain lead in solder, avoid unprotected skin contact with
the solder. Also, when soldering do not inhale any smoke or fumes produced.
NOTICE
(FOR CANADIAN MODEL ONLY)
Fuse symbols (fast operating fuse) and/or (slow operating fuse) on PCB indicate that replacement parts must
be of identical designation.
REMARQUE
(POUR MODéLE CANADIEN SEULEMENT)
Les symboles de fusible (fusible de type rapide) et/ou (fusible de type lent) sur CCI indiquent que les piŹces
de remplacement doivent avoir la m?me dŽsignation.
(FOR USA MODEL ONLY)
ANY MEASUREMENTS NOT WITHIN THE LIMITS
1. SAFETY PRECAUTIONS
OUTLINED ABOVE ARE INDICATIVE OF A POTENTIAL
The following check should be performed for the
SHOCK HAZARD AND MUST BE CORRECTED BEFORE
continued protection of the customer and service
RETURNING THE APPLIANCE TO THE CUSTOMER.
technician.
LEAKAGE CURRENT CHECK
Measure leakage current to a known earth ground (water2. PRODUCT SAFETY NOTICE
pipe, conduit, etc.) by connecting a leakage current tester
Many electrical and mechanical parts in the appliance
such as Simpson Model 229-2 or equivalent between the
have special safety related characteristics. These are
earth ground and all exposed metal parts of the appliance
often not evident from visual inspection nor the protection
(input/output terminals, screwheads, metal overlays, controlafforded by them necessarily can be obtained by using
shaft, etc.). Plug the AC line cord of the appliance directly
replacement components rated for voltage, wattage, etc.
into a 120V AC 60Hz outlet and turn the AC power switch
Replacement parts which have these special safety
on. Any current measured must not exceed 0.5mA.characteristics are identified in this Service Manual.
Electrical components having such features are identified
by marking with a on the schematics and on the parts list
Reading shouldin this Service Manual.
not be above
LeakageThe use of a substitute replacement component which does
0.5mA
Devicecurrent
not have the same safety characteristics as the PIONEER
undertester
testrecommended replacement one, shown in the parts list in
this Service Manual, may create shock, fire, or other hazards.
Test all
exposed metal Product Safety is continuously under review and new
surfaces
instructions are issued from time to time. For the latest
information, always consult the current PIONEER Service
Manual. A subscription to, or additional copies of, PIONEER
Also test with
plug reversedEarthService Manual may be obtained at a nominal charge from
(Using AC adapterground
PIONEER.
plug as required)
AC Leakage Test
2 |
ACEC
