CDJ-100S
1. SAFETY INFORMATION
This service manual is intended for qualified service technicians; it is not meant for the casual
do-it-yourselfer. Qualified technicians have the necessary test equipment and tools, and have been
trained to properly and safely repair complex products such as those covered by this manual.
Improperly performed repairs can adversely affect the safety and reliability of the product and may
void the warranty. If you are not qualified to perform the repair of this product properly and safely, you
should not risk trying to do so and refer the repair to a qualified service technician.
WARNING
This product contains lead in solder and certain electrical parts contain chemicals which are known to the state of California to
cause cancer, birth defects or other reproductive harm.
Health & Safety Code Section 25249.6 � Proposition 65
NOTICE
(FOR CANADIAN MODEL ONLY)
Fuse symbols (fast operating fuse) and/or (slow operating fuse) on PCB indicate that replacement parts
must be of identical designation.
REMARQUE
(POUR MODéLE CANADIEN SEULEMENT)
Les symboles de fusible (fusible de type rapide) et/ou (fusible de type lent) sur CCI indiquent que les
piŹces de remplacement doivent avoir la m?me dŽsignation.
(FOR USA MODEL ONLY)
1. SAFETY PRECAUTIONSANY MEASUREMENTS NOT WITHIN THE LIMITS
The following check should be performed for theOUTLINED ABOVE ARE INDICATIVE OF A PO-
continued protection of the customer and serviceTENTIAL SHOCK HAZARD AND MUST BE COR-
technician.
RECTED BEFORE RETURNING THE APPLIANCE
LEAKAGE CURRENT CHECKTO THE CUSTOMER.
Measure leakage current to a known earth ground
(water pipe, conduit, etc.) by connecting a leakage2. PRODUCT SAFETY NOTICE
current tester such as Simpson Model 229-2 or Many electrical and mechanical parts in the appli-
equivalent between the earth ground and all exposedance have special safety related characteristics. These
metal parts of the appliance (input/output terminals,are often not evident from visual inspection nor the
screwheads, metal overlays, control shaft, etc.). Plugprotection afforded by them necessarily can be ob-
the AC line cord of the appliance directly into a 120Vtained by using replacement components rated for
AC 60 Hz outlet and turn the AC power switch on. Anyvoltage, wattage , etc. Replacement parts which have
current measured must not exceed 0.5 mA.these special safety characteristics are identified in
this Service Manual.
Electrical components having such features are
identified by marking with a on the schematics and
Reading shouldon the parts list in this Service Manual.
not be aboveThe use of a substitute replacement component which
Leakage0.5 mA
currentdoes not have the same safety characteristics as the
Devicetester
underPIONEER recommended replacement one, shown in
test
the parts list in this Service Manual, may create shock,
fire, or other hazards.
Test all exposed
metal surfaces Product Safety is continuously under review and
new instructions are issued from time to time. For
Also test with plugthe latest information, always consult the current
reversed
PIONEER Service Manual. A subscription to, or ad-
(Using AC adapter
plug as required)ditional copies of, PIONEER Service Manual may be
Earth groundobtained at a nominal charge from PIONEER.
AC Leakage Test
2 |
ACEC
