CDX-FM1259,FM1257
12. To see the amount of dislocation, place the mechanism upside-down.
If the stopper bend has been dislocated in the direction of the first
VR802
CD, turn VR802 to the left(Fig. 2).
GND
EREF
To lower the stage toward the twelfth step by 0.1 mm, reduce the
voltage of EREF (adjusted in step 8) by 10 mV.
If the stopper bend has been dislocated in the direction of the twelfth
CD, turn VR802 to the right(Fig. 4).
To raise the stage toward the first step by 0.1 mm, increase the volt-
47k1
age of EREF (adjusted in step 8) by 10 mV.L.P.F.1?F
13. Place the mechanism horizontal. Go back to step 11 to reconfirm the
stage height.
Oscilloscope
14. When adjustment of the stage height is completed, proceed as fol-
lows:
15. Press the EJECT switch.
16. Once operation of the mechanism has stopped, turn the power OFF.
17. Wait more than one minute after the power is turned off, then turn the power ON and insert a magazine.
18. Check if the mechanism operates correctly with the first, sixth, seventh and twelfth CDs.
19. If the mechanism operates properly, adjustment is completed. If the mechanism operates improperly, make the
adjustment again.
41 |
ACEC
