DRM-7000, DRM-AF751, DRM-AL751, DRM-AH721, DRM-PW701
(3) Attaching the Inner Table Assy
1. Mount the Inner Table Assy so that the tip of the Planetary Arm
Assy is centered on the cutout of the Outer Table.
marks
Note : Make sure that the Inner Table Assy is not mounted
on the flange of the Outer Table.
SW arms C
Key-shaped axis of the
H cam gear (largest)
marks
Fig. 6
Planetary Arm Assy
Outer Table (cutout)
Planet Gear
Fig. 5
(4) Mounting the Swing-full Assy
1. Place the unit in the upright position with the left side of the unit
up (right side down). Use a soft cloth such as a rug to protect the(5) Attaching the SW Arms
Front Door.1. Attach the SW Arms as indicated in Fig. 7.
2. Align the largest, key-shaped axis of the H Cam Gear of theNote : There are three SW Arms, labeled A, B and C.
Carriage Base and two SW Arms C with the marks.
3. Turn the Inner Table of the Swing-full Assy completely
counterclockwise and keep it in that position.DCMB
Flexible cord ABOARDSW Arm A
ASSY(to outer cam groove)
Note : Grip the Chuck Assy and the Upper Plate firmly so
that the Inner Table will not return to its original position
under its spring tension.
4. Insert the Steel Ball into the slot of the Outer table.
5. Align the key-shaped slot of the Inner table with the key-shaped
axis of the H Cam Gear, and mount the Swing-full Assy.LoadingSW Arm C
Motor Assy
Note : While mounting the Inner Table, press it on so that the
Inner Table will not pop up from the Outer Table .
6. Slide the Lock Plate, and lock it.SW Arm C
SW Arm B
(to inner cam groove)
Note : Check that the Lock Plate is firmly locked by lifting the
Swing-full Assy.
SW Arm B
H cam gear
(to inner cam groove)
7. Rotate the Swing-full Assy one turn by rotating the Loading
Motor. If the SW C Arms are not seated in the cam grooves, theFig. 7
rotation will be locked midway. In such a case, remove the
Swing-full Assy and repeat steps 5 through 7.
8. Lay out the wire of the Sensor Stay and screw on the Sensor
Stay.
143 |
ACEC
