DRM-7000, DRM-AF751, DRM-AL751, DRM-AH721, DRM-PW701
Rear Door
1To manually open the Rear Door,
insert a thin rod, such as a small-
diameter screwdriver, diagonally
down approx. 50 mm through the
hole at the lower side of the rear
door.
32Press it down as shown in the
illustration. Then the Rear Door Reader2
can be manually opened.Drive
Unit
3
PL Lock Lever
Y The reader drive can be installed in any slot. (You can install
Rear Door
as many optional reader drives as there are slots available.)
Removing the PL Upper Cover of the
Drive Unit
The PL Upper Cover is fixed with Claws at the front and with
screws at the rear. To remove the PL Upper Cover, proceed
1
as follows. Failure to do so may damage the claws.
Thin rod, such as a small-
diameter screwdriver
2
5
Reader Drive Unit
PL Upper
Cover
While pressing the PL lock lever
toward RELEASE, slide the PL
4´4Upper Cover backward.
(It will stop after sliding approx.
1 cm backward.) Claws (both sides)
PL Upper Cover
7
Claw
1´3
6Press and bend the front part of the PL Upper Cover from
Remove three connectors.the left and right sides to unhook the claws, then lift up
the cover. (Do NOT try to lift up the cover forcibly with the
claws unhooked. This may damage the claws and make
it impossible to reattach the cover.)
Y When reattaching the cover, reverse the above procedures.
(Place the cover approx. 1 cm backward and hook the claws,
then slide the cover forward.)
Y Observe the driver unit from the rear to check that the claws
are firmly engaged.
139 |