1234
7.1.7 ID NUMBER AND ID DATA SETTING
Caution:
For the DVD players compatible with DVD-RW, for playback of a DVD-RW disc (CPRM), it is necessary that an individual ID
Anumber and ID data are set for each player. If the ID number and ID data be not properly set in the manner described below,
future operations cannot be guaranteed. The ID number is written on the yellow label at the rear panel of the player.
If there is no yellow label, before downloading FLASH ROM, take note of the ID number set following the procedures
outlined in "ID Number Confirmation Mode" on the next page.
Note: Enter ID numbers while the unit is in Stop mode so that the values set will be immediately written to the flash ROM.
The following operations are all made with the TEST MODE remote control unit (GGF1067).
ID Number Input Mode
1 To enter ID Number Input Mode, with no ID number set, such as 6 This display appears when the PLAY key is pressed in Step 4.
in a case of immediately after upgrading the firmware, press the Enter a 9-digit number to compare. The number is also
BESC key then the STEREO key.displayed on the FL display.
Note: If a previous ID number and ID data, such as a factory-7 By pressing the CLEAR key without having input a number, the
preset ID number and ID data, are maintained, the unit unit returns to Step 2 without doing anything else. Each press
enters ID Number Confirmation Mode when the above keys of this key after a number has been input deletes one digit.
are pressed. However, if only an ID number is maintained,
the unit enters ID Data Input Mode.
[Player's ID Number Setting]
ID Number ?
2 Enter a 9-digit ID number. The ID number is also displayed on
the FL display. 0 0 0 0 0 0 0 0 1
Compare
3 By pressing the CLEAR key without having input a number, you
can exit this mode. Each press of this key after a number has 6 >
been input deletes one digit.
C[Player's ID Number Setting]
ID Number ? Input ID Number !
2 > - - - - - - - - -
3 <CLEAR> Exit
8 After entering all 9 digits, if you press the PLAY key, the unit
compares the numbers input in Steps 2 and 6, and only if the
Input ID Number !
numbers match, that number is set as the ID. Then the unit
automatically enters ID DATA Input Mode. If the numbers do not
match, the disc tray is opened, and the unit exits ID Number
Input Mode.
DNote: If you press the PLAY button before inputting a 9-digit ID
4 After entering all 9 digits, if you press the PLAY key, the unit number, the unit returns to Step 6 without doing anything
enters Compare mode. Enter the same ID number again. Only else.
if your two input numbers match, the ID number is set. Compare
mode helps eliminate mistyping of the ID number.
[Player's ID Number Setting]
ID Number ?Note: If you press the PLAY button before inputting a 9-digit ID
number, the unit returns to Step 2 without doing anything
else. 0 0 0 0 0 0 0 0 1
Compare
5 After entering all 9 digits, if you press the SEARCH key, the
unit unconditionally sets the input number as the ID number. > 0 0 0 0 0 0 0 0 1 OK?
Then the unit automatically enters Player's Data Input Mode.
(The SEARCH key is not accepted after all 9 digits have been 8 <PLAY> Enter
entered.)
E Input ID Number !
[Player's ID Number Setting]
ID Number ?
> 0 0 0 0 0 0 0 0 1 OK ?
4 <PLAY> Compare Mode
5 <SEARCH> Enter
Input ID Number !
F
62DV-360-S
1234
ACEC
