1234
7. GENERAL INFORMATION
7.1 DIAGNOSIS
A7.1.1 ID NUMBER AND ID DATA SETTING
Entering the ID Number and ID Data for Players with DVD-Audio and DVD-RW
Compatibility
It is necessary with a player with DVD-audio and DVD-RW compatibility to set an individual number (ID number) and ID data. If the
number and data are not set correctly with the following procedure, operations in the future may not be guaranteed. You will find the ID
number to be set on the yellow label on the rear panel.
Important: If no yellow label is found on the rear panel, write down the specified ID number by checking it according to "How
to confirm the ID number" shown below.
The Input is Necessary When:
BY Downloading FLASH-ROM is finished. (The latest version must be downloaded when a repair is made.)
Y "No ID Number" is displayed on the screen or FL display immediately after the power is turned on or in Stop mode.
Y If "No ID DATA" is displayed, the ID data must be entered.
Note:
Be sure to enter the ID number in Stop mode.
Use the service remote control (GGF1381) for operations. Only opening/closing of the tray are performed from the player.
Use Disc No. : GGV1133
How to Input the ID Number and ID Data
C1 To enter the input mode, press ESC + STEREO in a status with 4 When the ID number has been registered, the unit enters the
no ID number set, such as after FLASH-ROM downloading.ID data input mode. (The FL display indicates "NO ID DATA.")
In this condition, place the ID data disc on the tray and close
the tray using the CLOSE key "7/0" on the player.
2 As number input is enabled when the unit enters the input [Player's ID Data Setting]
mode, input the 9-digit ID number.
(The entered number is also displayed on the FL display.)
[Player's ID Number Setting]
<CLEAR> Exit
ID Number ?
2> - - - - - - - - -
4Insert The ID Data Disc !
D<CLEAR> Exit
Input ID Number !
5 While the data are being read, the message shown in the
figure at left is displayed on the screen.
(The FL display indicates "RD ID DATA.")
3 After inputting the number, press SEARCH to register the ID
number.[Player's ID Data Setting]
[Player's ID Number Setting]
E ID Number ?
> 0 0 0 0 0 0 0 0 1 OK ?
<PLAY> Compare Mode
3<SEARCH> Enter
5Loading The ID Data Disc !
Input ID Number !
F
82DV-59AVi
1234
ACEC
