InstallationInstallationInstallationInstallation
Y If installation angle exceeds 30! from horizon-DIN front-mountDIN rear-mountFixing the front panel
Notes
tal, the unit might not give its optimum perfor-
Y Before finally installing the unit, connect themance. (Fig. 7)If you do not operate the Detaching and Replacing the Front Panel Function, use the supplied fixing
wiring temporarily, making sure it is all con-screws and holder to fix the front panel to this unit.
Installation with the rubber bush (Fig .9)
nected up properly, and the unit and the sys-Installation using the screw holes on the side of the unit (Fig. 12) (Fig. 13)
tem work properly.(Fig. 14)1. Attach the holders to both sides of the front panel. (Fig. 15)
Holder
Y Use only the parts included with the unit to
After inserting the holder into the dash-board, then
ensure proper installation. The use of unautho-
select the appropriate tabs according to the thick-1 Remove the frame. (Fig.12)
rized parts can cause malfunctions.
Dashboardness of the dash-board material and bend them.Holder
Y Consult with your nearest dealer if installation
(Install as firmly as possible using the top and
requires the drilling of holes or other modifica-182
bottom tabs. To secure, bend the tabs 90 degrees.)
tions of the vehicle.
Fig. 7
Y Install the unit where it does not get in the53Fig. 15
Y The cords must not cover up the area shown inRubber bush
driverOs way and cannot injure the passenger if
the figure below. This is necessary to allow the
there is a sudden stop, like an emergency stop.Insert the release pin into the2 Replace the front panel to the unit. (Fig. 16)Screw
Y The semiconductor laser will be damaged if itamplifires to radiate freely. (Fig. 8)hole in the bottom of the
overheats, so donOt install the unit anywhereframe and pull out to remove
hot N for instance, near a heater outlet.the frame. (When reattaching
Frame
the frame, point the side with
Fig. 9a groove downwards and
attach it.)
Removing the unit (Fig. 10) (Fig. 11)
Do not close this area.
FrameFig. 12
2 Fastening the unit to the factory radio mounting bracket. (Fig. 13) (Fig. 14)
Fig. 8Insert the release pin into the hole
Fig. 16
in the bottom of the frame andSelect a position where the screw holes of the
bracket and the screw holes of the head unit3. Flip the holders into upright positions. (Fig. 17)pull out to remove the frame.
DIN front/rear-mount
(When reattaching the frame,become aligned (are fitted), and tighten the
This unit can be properly installed either from OFront� (conventional DIN Front-mount) or ORear� (DINpoint the side with a groove down-screws at 2 places on each side. Use either
wards and attach it.)
Rear-mount installation, utilizing threaded screw holes at the sides of unit chassis). For details, refer totruss screws (5 � 8 mm) or flush surface
the following illustrated installation methods.screws (5 � 9 mm), depending on the shape of
the screw holes in the bracket.
Fig. 10
Fig. 13
Fig. 17
Insert the supplied extraction
keys into the unit, as shown in
Screw
Factory radio mounting bracket4 Fix the front panel to the unit using fixing screws. (Fig. 18)the figure, until they click into
place. Keeping the keys pressed
against the sides of the unit,
pull the unit out.Fixing screw
Fig. 18
Dashboard or Console
Fig. 11Fig. 14 |
ACEC
