DV-505, DVL-909, DV-S9
3.4 EXPANSION FUNCTION 13.5 EXPANSION FUNCTION 2
Set the reception mode of expansion function by pressing [TEST]Set the reception mode of expansion function 2 by pressing [HILITE/
(5E) key of the test mode remote control unit, then expansion functionINTRO] (55) key of the remote control unit, then expansion function
is able to execute by pressing the key of [0] to [9].2 is able to execute by pressing the key of [0] to [9].
Indication for the most significant digit becomes "T" during the
reception mode of expansion function. (This mode can on and off
(1) Forced DVD Setting
with toggle.)
In the checker mode, set up the condition that DVD is attached
forcibly except for the result of disc distinction by pressing [HILITE/
(1) LD OnINTRO] and [1] keys in order.
Turn the laser diode to on by pressing [TEST] and [1] keys in order.In the no checker mode (normal test mode), once execute the setting
but abandan it soon.
Therefore, perform the disc distinction again for the safety when
(2) Focus On
rising up the player in this condition.
Focus locks by pressing [TEST] and [2] keys in order.
(2) Forced CD Setting
(3) Focus Sweep
In the checker mode, set up the condition that CD is attached forcibly
Repeat focus sweep by pressing [TEST] and [3] keys in order.
except for the result of disc distinction by pressing [HILITE/INTRO]
and [3] keys in order.
(4) Spindle FG Servo
In the no checker mode (normal test mode), once execute the setting
Rising up the spindle and FG servo becomes on by pressing [TEST]but abandan it soon.
and [5] keys in order.Therefore, perform the disc distinction again for the safety when
rising up the player in this condition.
(5) AGC On/Off
Switch the AGC on and off with toggle by pressing [TEST] and [7](3) Execute The Disk Distinction
keys in order.
In the checker mode, execute the disc distinction result by pressing
[HILITE/INTRO] and [0] keys in order.
(6) Jitter Value Indication.
It becomes the jitter-value indication mode by pressing [TEST] and
[DIG/ANA] keys in order.
(7) DSP coefficient indication of FTS system.
Set up the address (four digits) of the coefficient that it wants to see
by the point of search address input, then real time indicates the
coefficient in OSD by pressing [TEST] and [9] keys in order.
(8) CD Error Rate Indication
Indicate the value in OSD after measuring is completed by pressing
[TEST] and [0] keys in order after set up the measuring time (1 to 8
seconds) by the point of search address input.
3.6 List of Test Mode Function
Key Name ofMode of
Contents of CommandCondition
Remote Control UnitRemote Control Unit
OpenSTOPREPEAT AA8-48
CloseOPENREPEAT AA8-48
StopPLAYREPEAT BA8-44
Play (DVD is only tracing.)STOPTV/LDPA8-0F
Play (DVD is with decode.)STOPPLAYA8-17
Pause onPLAYCXA8-0E
Pause on/offPLAY/PAUSEPAUSEA8-18
Search address input (0 to 9)0 to 9A8-00 to 09
*Use for other numerical value input
15 |
ACEC
