1234
6.3 SERVICE MODE LIST
This unit provided with the following SERVICE MODES so you can repair, examine and adjust easily.
To enter to the SERVICE MODE function, press and hold both buttons simultaneously on the main unit or on the main unit
A
and on the remote control for more than a standard time in the appropriate condition. (See below chart.)
In case of the main unit and remote control, press the remote control buttons first, then press the main unit buttons.
SetStandard
Set KeySet KeyOperations
ConditionTime
PLAY/REC total hours are displayed on the TV Monitor.
Refer to the OPREVENTIVE CHECKS AND SERVICE INTERVALS�
VCR modeCH UPFF2 sec.(CONFIRMATION OF HOURS USED).
Can be checked of the INITIAL DATA of MEMORY IC.
Refer to the OWHEN REPLACING EEPROM (MEMORY) IC�.
B
Initialization of the factory on VCR.
NOTE: Do not use this for the normal servicing.
VCR modeCH UPPLAY2 sec.
If you set a factory initialization, the memories are reset such as the
clock setting, the channel setting, and PLAY/REC total hours.
VCR modeAdjust the PG SHIFTER automatically.
CH UPSTOP2 sec.
(Playback)Refer to the OELECTRICAL ADJUSTMENT�.
VCR operation mode at no connection of DVD.
Power OffCH DOWNPOWER2 sec.
Refer to the OPREPARATION FOR SERVICING�
NOTE: Although the DVD is connected, the DVD mode cannot be selected.
CSetRemoconStandard
Set KeyOperations
ConditionKeyTime
Initialization of the factory on DVD.
NOTE: Do not use this for the normal servicing.
DVD mode
REC/OTR42 sec.This function will only work without the setting of DVD disc at DVD
(No disc)
mode. While pressing the Remocon Key for more than 2 seconds,
press the Set Key simultaneously.
Releasing of PARENTAL LOCK.
DVD modeRefer to the OPARENTAL CONTROL - RATING LEVEL�.
(No disc)STOP73 sec.NOTE: The function will only work without the setting of DVD disc at DVD
mode.
D
MethodOperations
Press the ATR button on the remote Adjusting of the Tracking to the center position.
control for more than 2 seconds during Refer to the OMECHANICAL ADJUSTMENT� (GUIDE ROLLER) and OELECTRICAL
PLAY.ADJUSTMENT� (PG SHIFTER).
Make the short circuit between the test The BOT, EOT, and the Reel Sensor do not work and the VCR deck can be operated
point of SERVICE and the GND.without a cassette tape.
Refer to the OPREPARATION FOR SERVICING�
E
F
76DV-PT100-S
1234 |
ACEC
