1234
How to Input the ID Number and ID Data
A
1 To enter the input mode, press ESC + STEREO keys 5 While the data are being read, the message shown in the figure
sequentially in a status with no ID number set, such as after at left is displayed on the screen.
FLASH-ROM downloading.(The FL display indicates "LOAD ID.")
2 As number input is enabled when the unit enters the input [Recorder's ID Data Setting]
mode, input the 9-digit ID number.
(The entered number is also displayed on the FL display.)
[Recorder's ID Number Setting]
ID Number ?
> - - - - - - - - -
B2
5Loading The ID Data Disc !
<CLEAR> Exit
Input ID Number !
6 When the ID data have been read, the data are written to the
FLASH-ROM.
(The FL display indicates "WRITE ID.")
3 After inputting the number, press SEARCH keys to register the
ID number.
C
[Recorder's ID Data Setting]
[Recorder's ID Number Setting]
ID Number ?
> 0 0 0 0 0 0 0 0 1 OK ?
6Wait Rom Writing !
<PLAY> Compare Mode
3<SEARCH> Enter
Input ID Number !
D
4 When the ID number has been registered, the unit enters the ID 7 When the ID data have been written to the FLASH-ROM, the
data input mode. (The FL display indicates "INSERT ID.")message "Rom Write OK" is displayed on the screen.
In this condition, place the ID data disc on the tray and close the (The FL display indicates "ID OK.")
tray using the CLOSE key "7/0" on the player.
8 After confirming this message, press CLEAR key to exit the
[Recorder's ID Data Setting]input mode.
[Recorder's ID Data Setting]
<CLEAR> Exit
7Rom Write OK !
E
4Insert The ID Data Disc !
8<CLEAR> Exit
F
DVR-RT602H-S110
1234
ACEC
