GM-222
)
WWW
1 (EIAJ)
´allowable)allowable)
175 (D) mmWW
6-7/8 (D) in.]
´
´
for two channels)for one channel)
W
W(2 N 8
52 (H) 2 / 160 W dB (IHF�A network)
´´W
2-1/8 (H)
1 (DIN45324,+B=14.4 V)
6.0 A (4 ´´....105 dB (IEC�A network)
A (at continuous power,470 W
.............................Negative type...3.5 A (4 ,20 N 20,000 Hz,0.08% THD),20 N 20,000 Hz,0.8% THD),20 N 20,000 Hz,0.8% THD)
V DC (10.8 N 15.1 Vallowable)) (Leads for wiring not included)WWW............4 10 N 50,000 Hz (+0 dB,�1 dB)...........RCA:0.4 N 4 V / 22 k
....216 (W)
....................................60 dB (1 kHz)
[8-1/2 (W) ........................0.004% (10 W,1 kHz)
........................................................20 A2 / 125 W (Bridge connection:4 N 8
´Speaker (UC model):1.6 N 10 V / 40 k
1 (at 14.4V,4 2 (at 14.4V,2
2 (at 14.4V,4 ´´
´
80 W 50 W
SPECIFICATIONS
due to improvements.when an audio signal is input. Use this value when working out total current drawn by multiple power amplifiers.
Power source..............................................................................................................14.4 Grounding system...............................................................................................................Current consumption........................................................................................................12.5Average current drawn*.........................................................................................................Fuse ..........................................................................................................................Dimensions ....................................................................................................................Weight ........................................................................................................2.1 kg (4.7 lbs.Maximum power output ..........................................................................................................Continuous power output (UC and ES models)..........................35 W Continuous power output (EW model) ......................................................55 W Load impedance ................................................................................................................Frequency response ............................................................................................................Signal-to-noise ratio (UC and ES models)....................................................................................105Signal-to-noise ratio (EW model) ..............................................................................................Distortion ....................................................................................................................Separation ....................................................................................................................Input level / impedance .......................................................................................................Note:YSpecifications and the design are subject to possible modification without notice*Average current drawnYThe average current drawn is nearly the maximum current drawn by this unit
-
Fig. 22
Speaker(Mono)
(Left) Speaker (Right)
Fig. 21
The speaker output mode can be two-channel (stereo), one-channel (mono). To connect the speaker leads to suit the mode. Connect the speak- ers according to figures on the following pages.
Two-channel mode (stereo) One-channel mode (mono)
(2) ES and EW models
19 |
ACEC
