GM-X432,X332
Amplifier with RCAinput jacksCar stereo with RCAoutput jacks
External OutputRCAinput jack
RCAinput (sold separately)
Special red battery wire [RD-222] (sold separately). After making all other connections at the amplifier, connect the battery wire terminal of the amplifier to the positive (+) terminal of the battery.Ground wire (black) [RD-222](sold separately). Connect to metal body or chassis.Connecting wires with RCApin plugs(sold separately).
System remote control wire (sold separately) Connect the male terminal of this wire to the system remote con- trol terminal of the car stereo (SYSTEM REMOTE CONTROL). The female terminal can be connected to the auto-antenna relay control terminal. If the car stereo does not have a system remote control terminal, connect the male terminal to the power terminal through the ignition switch.
RCAoutput jack
Fuse (30 A)
GrommetFuse (20 A)
Connection DiagramSpeaker terminal See the OConnecting the Speaker wires� section for speaker connection instructions.
W
YMake sure that wires will not interfere with
moving parts of the vehicle, such as the gearshift, handbrake or seat sliding mechanism.tion circuit may fail to work when it should.the insulation of the power supply wire to tap from the wire. The current capacity of the wire will be exceeded, causing overheating.as far away as possible from the speaker wires. Install and route the sold separately battery wire and ground wire, speaker wires, and the amplifier as far away as possible from the antenna, antenna cable and tuner.conform with the standards listed below. Otherwise damage will occur to the speaker. The speaker impedance must be 1 to 8 ohms.(2 to 8 for stereo, monaural and other bridge connec- tions.)
YDo not shorten any wires. Otherwise the protec-YNever feed power to other equipment by cuttingYInstall and route the sold separately battery wireYSpeakers to be connected to the amplifier should
Sub-wooferNominal input: Min.35WOther than sub-wooferMax. input: Min.70 WSub-wooferNominal input: Min.100WOther than sub-wooferMax. input: Min.200 W
CAUTIONTo prevent damageSpeakerChannelSpeakerTypePowerTwo-channelOne-channel
Connecting the Unitavoid the risk of short-circuit and damage to the unit.tape. To protect the wiring, wrap adhesive tape around them where they lie against metal parts.example where the heater will blow over them. If the insulation heats up, it may become damaged, resulting in a short-circuit through the vehicle body.nect a negative (�) lead wire for several speakers.negative grounding. Before installing it in a recre- ational vehicle, truck, or bus, check the battery voltage.the engine is at rest or idling, the battery may go dead. Turn the car stereo off when the engine is at rest or idling.is connected to the power terminal through the ignition switch (12 VDC), the amplifier will always be on when the ignition is onN regardless of whether the car stereo is on or off. Because of this, the battery could go dead if the engine is at rest or idle.
YRemove the negative (�) terminal of the battery toYSecure the wiring with cable clamps or adhesiveYDo not route wires where they will get hot, forYDo not ground the speaker wire directly or con-YThis unit is for vehicles with a 12-volt battery andYIf the car stereo is kept on for a long time whileYIf the system remote control wire of the amplifier
17 |
ACEC
