16 April ?88
NOTE 1:
For sales demonstrations, you can turn on the all indicators without using DIP
SW1 -8. The procedure is as follows:
1. Press the Mode Clear key.
2. Press the c/s key, thenpress the Enter key.
3. Enter ?11? using the numeral keys.
4. Press the Enter key. To clear this mode, pressthe Mode Clear key.
NOTE 2: SP Mode No.60
For the color toner supply recovery, the following procedure is required:
1. Turn off the main switch and turn on DIP switch 1-2.
2. Turn on the main switch, then press theStart key.
3. While pressing the enter key and the ?O? key, the toner supply clutch turns
on.
4. Press the Clear/Stop key and turn off the main switch, then turn offDIP
switch 1 -2.
NOTE 3: SP Mode No.29
The idling mode may be necessary if the copier has been installed in an
environment with low temperature conditions. The idling mode willwarm up
the fusing rollers enough to ensure the fusing ability at initial copy run.
Idling Mode:The copier will idle for 10 seconds when the Start key is
pressed for the first time after the main switch is turned on.
NOTE: Idling cannot be performed if the machine?s temperature is more
4-12 |
ACEC
