5 Disassembly and Reassembly
5-1-2 Removing the Entire PCB Assembly5-1-3 Removing the CRT Socket PCB
1. Complete all previous steps.1. Complete all previous steps.
2. Using pinch-nosed pliers or long-nosed pliers,2. Disconnect connectors CN104B, CN104RG and
carefully disconnect the Anode Cap from theG2 (GTP902) on the CRT Socket PCB.
CRT.3. Hold the CRT Socket PCB Assembly while
3. Disconnect connector GTP901 on the CRTyou lift the Cap on the CRT Socket and
Socket PCB.desolder the two focus wires.
4. Disconnect the CRT Socket PCB Assembly.
5-1-4 Removing the Video PCB
5. Disconnect connectors CN401_1~CN401_4,
C301_1~CN301_3, CN403, CN404 and CN4051. Complete all previous steps.
on the Main PCB and CN605, CN606 on the2. Disconnect connector CN801 on the Video
Power PCB.PCB.
3. Remove both side screws on the Video PCB
Assembly Rear Shield.
4. Lift off the Video PCB Assembly.
Figure 5-5
6. Remove the 3 screws on the Main PCB Chassis
Bracket.
7. Lift off the entire PCB Assembly and place itFigure 5-7
on a flat, level surface that is protected from
Static electricity.5. Remove all screws on the Video PCB
Assembly and remove the Video Shield.
6. Remove the 3 screws on the Video PCB.
7. Lift out the Video PCB and place it on a flat,
level surface that is protected from static
electricity.
Figure 5-6
Figure 5-8
5-2SyncMaster 1000s (CGP1607L) |
ACEC
