13VT-N200
CHECKING THE VIDEO SEARCH REWIND
BACK TENSION
Y Remove the cassette housing control assembly.
Y After short-circuiting TP7701 and TP7702 pro-
Tension gauge
Pinch roller
vided at the left on the main PWB, plug in the900 - 1,200g
power cord, then turn on the power.
Y Checking
1. After pressing the play button, press the rewind but-
ton, and set the video search rewind mode.
Capstan shaft
2. Place the torque gauge on the take-up reel disk, and
turn it counterclockwise very slowly (one rotation everyTension gauge adapter
2 to 3 seconds) and check that the torque is within the
set value 3.4 ? 1.5mNAm (35 ? 15gfAcm).
Figure 1-13.
Torque gauge
1. Detach the pinch roller from the capstan shaft.
Do not separate excessively. Or the pinch lever and
pinch double action lever may disengage.
2. Engage the tension gauge adapter with the pinch
CCWroller shaft, and pull in the arrow direction.
3. Gradually return the pinch roller, and measure the
pulling force when the pinch roller contacts the cap-
stan shaft.
Take-up reel disk4. Make sure that the measured value is within setting
0.9 to 11.8 N (900 to 1,200g).
CHECKING AND ADJUSTMENT OF TENSION
POLE POSITION
Y Remove the cassette housing control assembly.
Figure 1-12.
Y After short-circuiting TP7701 and TP7702 pro-
vided at the left on the main PWB, plug in the
Notes:power cord, then turn on the power.
Set the torque gauge securely on the take-up reel disk.
If it is not secure, the measurement will be incorrect.Y Setting
1. Open the cassette tape (T-120), and fix with tape.
CHECKING THE PINCH ROLLER PRESSURE2. Set the cassette tape in loading state.
Y Remove the cassette housing control assembly.3. Put the weight (500g) on the cassette tape.
4. Make the adjustment with the beginning of a T-120
Y After short-circuiting TP7701 and TP7702 pro-tape.
vided at the left on the main PWB, plug in the(T-120)
power cord, then turn on the power.
Y Checking
Press the play button to set the playback mode.
500g
Weight to prevent
float (500g)
Figure 1-14.
Y Checking
1. Set a cassette tape, push the REC button to place the
unit in the SP record mode. Now check the tension
pole position.
27 |