14A1-RU
14A2-RU
1.5kV(at
?
2-2
A) for the set.mA) in the case of the set. The set has been factory - Adjusted to the above-
m
IMPORTANT SERVICE NOTES
forget to check for such high voltage after the work.
*If there is a possibility that the high voltage fluctuates as a result of the repairs, never
the high voltage completely.beam 0.1 beam 800 mentioned high voltage.cause excess X-ray radiation.lodged between the chassis and other metal parts in the receiver.cabinet backs, adjustment and compartment covers or shields, isolation resistor- ca- pacity networks, mechanical insulators etc.
Maintenance and repair of this receiver should be done by qualified service personnel only.SERVICE OF HIGH VOLTAGE SYSTEM AND PIC- TURE TUBEWhen servicing the high voltage system, remove static charge from it by connecting a 10K ohm Resistor in series with an insulated wire(such as a test probe) between picture tube dag and 2nd anode lead. (AC line cord should be disconnected from AC outlet.)1.Picture tube in this receiver employs integral implosion protection. 2.Replace with tube of the same type number for continued safety. 3.Do not lift picture tube by the neck. 4.Handle the picture tube only when wearing shatterproof goggles and after dischargingX-RAYThis receiver is designed so that any X-Ray radiation is kept to an absolute Minimum. Since certain malfunctions or servicing may produce potentially hazardous radiation with prolonged exposure at close range, the followin precautions should be observed:1.When repairing the circuit, be sure not to increase the high voltage to more than 23.5kV(at2.To keep the set in a normal opeartion , be sure to make it function on 22.0kV 3.Do not substitute a picture tube with unauthorizerd types and/or brands which mayBEFORE RETURNING THE RECEIVERBefore returning the receiver to the user, perform the following safety Checks.1.Inspect all lead dress to make certain that leads are not pinched or that hardware is not2.Inspect all protective devices such as non-metallic control knobs, insulating fishpapers,
Height: 361.0mm Depth: 368.7mmHeight: 333.0mm Depth: 365.0mm
Weight (approx.): 9.2 kg Weight (approx.): 9.4 kg
NTSC 3.58/4.43 MHz (AV)
C1 (49.75MHz) thru C12 (216.25MHz) S1 (105.25MHz) thru S41 (463.25MHz)
C13 (471.25MHz) thru C57 (863.25MHz)
2-1
SPECIFICATIONS
Specifications are subject to change without prior notice.
5.5MHz.............................................................................................33.4MHz 6.0MHz.............................................................................................32.9MHz 6.5MHz.............................................................................................32.4MHz14A1-RU..................................................................................................65W 14A2-RU..................................................................................................68W14A1-RU.......................................................................5 x 9 cm Elliptic (1 pc) 14A2-RU....................................................................5 x 9 cm Elliptic (2 pcs.)
Picture IF Carrier..................................................................................38.9MHz Sound IF Carrier FrequencyColour Sub-Carrier Frequency...........................................................34.47MHzSizeVoice Coil Impedance...........................................................16 ohms at 400 HzVHF/UHF..........................................................................75 ohms Unbalanced Receiving System.....................................................PAL B/G, D/K, I / SECAMY VHF-Channels.....................................E1 (48.25MHz) thru E12 (224.25MHz)Y UHF-Channels.................................E21 (471.25MHz) thru E69 (855.25MHz)14A1-RU...................................................................................Width: 357.0mm14A2-RU...................................................................................Width: 446.0mm
Convergence.................................................................Self Convergence System Focus............................................................Electrostatic Focus High Bi-PotentialSweep Deflection.....................................................................................Magnetic Intermediate FrequenciesPower Input.....................................................................110 ~ 240V AC 50/60 Hz Power ConsumptionAudio Power Output Rating 14A1-RU.........................................................................................3.0W (at Max.) 14A2-RU.........................................................................................5.0W (at Max.)SpeakerAerial Input ImpedanceTuner RangesDimensionsCabinet Material....................................................................................All Plastics
2 |
ACEC
